User manual STANTON STR8100

[. . . ] For products intended to operate from battery power, or other sources, refer the operating instructions. 10. Grounding or Polarization ­ This product may be equipped with a polarized alternation-current line plug (a plug having one blade wider than the other). This plug will fit into the power outlet only one way. If you are unable to insert the plug fully into the outlet, try reversing the plug. [. . . ] All other servicing should be referred to qualified service personnel. Ventilation ­ Slots and openings in the cabinet are provided for ventilation and to ensure reliable operation of the product and to protect it from overheating, and these openings must not be blocked or covered. The openings should never be blocked by placing the product on a bed, sofa, rug, or other similar surface. This product should not be placed in a built-in installation such as a bookcase or rack unless proper ventilation is the manufacturer's instructions have been adhered to. Attachments ­ do not use attachments not recommended by the product manufacturer as they may cause hazards. Accessories ­ Do not place this product on an unstable cart, stand, tripod, bracket, or table. The product may fall, causing serious injury to a child or adult, and serious damage to the product. Use only with a cart, stand, tripod, bracket, or table recommended by the manufacturer, or sold with the product. Any mounting of the product should follow the manufacturer's instructions, and should use a mounting accessory recommended by the manufacturer. IMPORTANT SAFETY INSTRUCTIONS 21. Lightning ­ For added protection for this product during a lightning storm, or when it is left unattended and unused for long periods of time, unplug it from the wall outlet and disconnect the antenna or cable system. This will prevent damage to the product due to lightning and power-line surges. 20) DIGITAL OUT Use this output to connect your STR8-150 to any SPDIF in equipped digital device such as a CD-R or Computer. 21) POWER CORD CONNECTOR Used to connect the included power cord. 15 14 2 13 12 +2 g 3 1 11 4 1) START/STOP Press this button to start or stop the platter. 2) STROBE DOTS The dots around the edge of the platter are used in conjunction with the light located inside the motor ON/OFF switch. While the platter is in rotation, the dots help to indicate the speed of rotation. The speed is lower than the displayed speed (33, 45, 78) when the dots are flowing to the right. It is higher than the displayed speed (33, 45, 78) when the dots are flowing to the left. When the strobe is stopped, the platter is rotating at the displayed speed. 3) MOTOR ON/OFF SWITCH As opposed to fully analog turntables, this is not the power switch. This switch only turns on or off the motor. The platter will not start spinning until the start/stop button has been pressed. Rotate counter-clockwise during playback (off position) for a slow winding down effect. [. . . ] Exceptions to this warranty are as noted below: The warranty for mechanical parts which are subject to wear and tear are limited to the earlier to occur of thirty (30) days following the date of original purchase or the following number of cycles: Faders - 15, 000; Rotary potentiometers - 10, 000; and Switches - 10, 000. Stanton will warrant all replacement parts and repairs for ninety (90) days from the date of original shipment. Repairs made necessary by reason of misuse, alteration, normal wear, or accident are not covered under this warranty. RETURNS Authorized Stanton dealers are only authorized to sell and distribute merchandise within a specific country. All goods requiring warranty repair or replacement must be returned (freight prepaid if not hand-delivered) to the authorized Stanton dealer from whom the merchandise was purchased and in the same country where the merchandise was purchased. [. . . ]