User manual STEELSERIES STEREO HEADSET 5H V2 USB

[. . . ] NÄR DENNA DEL ÄR ÖPPNAD OCH UND VORSICHT UNSICHTBARE LASERSTRAHLUNG WENN ABDECKUNG GEÖFFNETAUSSETZEN. VARNING OSYNLIG LASERSTRÅLNING FARLIG. STRÅLEN ÄR SICHERHEITSVERRIEGELUNG ÜBERERÜCKT. NICHT DEM STRAHL AVATTAESSA JA SUOJALUKITUS OHITETTAESSA OLET ALTTIINA NÄKYMÄTÖNTÄ USYNLIG LASERSTRÅLING VED ÅBNING, NÅR SIKKERHEDSAFBRYDERE ER ADVARSEL UDE AF FUNKTION. [. . . ] · Before feeding originals in the original feeder tray, be sure to remove any staples or paper clips from them. · Before placing curled or wavy originals into the original feeder tray, be sure to flatten them. · The SPF/RSPF ( ) indicator on the operation panel will light up. If this indicator does not light up, the originals are not properly set or the SPF/RSPF is not properly closed. · Badly damaged originals may misfeed in the SPF/RSPF. It is recommended that such originals be copied from the original table. · Special originals such as transparency film should not be fed through the SPF/RSPF, but should be placed directly on the original table. 4 mm) can occur at the leading and trailing edges of the copies. 4. 5 mm in total) can occur along the other edges of the copies. It can be 6 mm (max. ) at the trailing edge of the second copy of two-sided copying. · To stop continuous copying using the SPF/RSPF, press the clear ( ) key. One or two exposure indicators corresponding to the automatic exposure level which has been selected will light up. Press the light ( ) or dark ( ) key to lighten or darken the automatic exposure level as desired. If exposure level 2 is selected, the two left-handmost indicators for that level will light up simultaneously. Also, if level 4 is selected, the two righthandmost indicators for that level will light up simultaneously. The AUTO indicator will stop blinking and light up steadily. 4 5 50 REDUCTION/ENLARGEMENT/ZOOM Three preset reduction ratios and two enlargement ratios can be selected. The zoom function enables copy ratio selection from 25% to 400% in 1% increments. 1 2 Set the original and check the paper size. Use the copy ratio selector key and/or zoom ( select the desired copy ratio. , ) keys to · To verify a zoom setting without changing the zoom ratio, press and hold down the copy ratio display (%) key. When the key is released, the display will return to the copy quantity display. · To reset the ratio to 100%, press the copy ratio selector key repeatedly until the 100% indicator lights up. 3 Set the reduction/enlargement ratio. To decrease or increase the zoom ratio rapidly, press and hold down the ( ) or ( ) key. However the value will stop at the preset reduction or enlargement ratios. [. . . ] Limited Warranty on Media. STEELSERIES warrants the disks on which the Software is recorded to be free from defects in materials and workmanship under normal use for a period of ninety (90) days from the date of purchase as evidenced by a copy of the receipt. The entire liability of STEELSERIES and/or its Licensors and your exclusive remedy will be replacement of the disk which fails to meet the limited warranty provided by this Clause 6. A disk will be replaced when it is returned to STEELSERIES or a STEELSERIES authorized representative with a copy of the receipt. STEELSERIES will have no responsibility to replace a disk damaged by accident, abuse or misapplication. [. . . ]