User manual STEINEL HF 360 COM 1

[. . . ] 26 Adding/removing laundry during a wash program . 27 2 Contents Cleaning and care . 27 Cleaning the exterior and control panel . 29 Cleaning the drain pump and lint trap . [. . . ] The overall program time may be shortened or lengthened. Additionally the sequence cycle is displayed. The washer shows the current program step. The drum light turns off once the program starts. ^ With every touch of the "Delay" button, the start is delayed longer. ­ For a delay less than 10 hours, the delay time extends in 30 minute increments. ­ For a delay time more than 10 hours, the delay time extends in 1 hour increments. 23 Using the washer 10. Activate the Child Lock (if desired) The Child Lock can be activated to prevent a child from canceling the program and opening the door at the end of a program. ^ Press and hold the "Heavy soil" button until the display shows: 11. Program end During the "Anti-crease" program the display shows "Anti-crease" alternating with "End". ^ Open the drum door and remove the laundry. Check the drum for any missed pieces of laundry. Load the laundry Duration: MG G P G G GM Warm 1:02 h MG G G G P GM High spin By pressing the left button the temperature will be adjusted. Pressing the right button modifies the spin speed. ^ Press the "Door" button and load the laundry. To prevent damage to the door seal and clothing, make sure that there are no clothes caught between the drum door and the seal. Quick guide 6. Selecting Delay Start ^ Press the "m" delay start button. Start in: MG G P G G GM Warm 1:02 h MG G G G P GM High spin ^ With every touch of the "m" delay start" button, the start is delayed longer. Starting a program ^ Select the desired Option with the respective button. Once an Option is selected, the indicator lights. Add detergent ^ Press the flashing "Start" button. Activating the Child Lock ^ Press and hold the "Heavy Soil" button until the display shows: X Locked ^ Deactivate the Child Lock after the program has finished. Unload the laundry ^ Open the drum door. ^ Add detergent to the respective compartments. [. . . ] Tips for a hot water connection The hot water temperature from the hot water valve must not exceed 140°F (60°C); the ideal temperature is 130°F (55°C). If there is no water pressure at the hot water inlet, the unit will automatically switch to cold water after several minutes. 47 Plumbing Drainage The 5 ft (1. 5 m) drain hose may be connected as follows: 1. Directly into a sink: hook the hose over the edge of the sink and secure it firmly (e. g. To a stand pipe: place the drain hose into a 1 ½" (4 cm) stand pipe and secure it firmly. [. . . ]