User manual STEINEL NIGHTMATIC 3000

[. . . ] 86/108 Avenue Louis Roche F-92230 Gennevilliers Cedex Tel. : + 33/141 472 040 e-mail:sav@duvauchel. fr NL KARL H STRÖM AB Verktygsvägen 4 S-553 02 JÖNKÖPING Tel. : + 46/36/31 42 40 DK LOG Zabnica D. O. O. Podjetje Za Trgovino SLO-4209 Zabnica Tel. : +3 86/42/31 20 00 GR Bedienungsanleitung Operating instructions Mode d'emploi Gebruiksaanwijzing Istruzioni per l'uso Instrucciones de montaje Bruksanvisning Brugsanvisning Käyttöohje Bruksanvisning FIN 7216800 Technische Änderungen vorbehalten. HEGEMA PRESENT B. Christiaan Huygensstraat 4 NL-3291 CN Strijen Tel. : + 31/78/6 74 44 44 B BROMMANN Ellegaardvej 18 DK-6400 Sønderborg Tel. : + 45/74 42 88 62 Hedengren Yhtiöt Oy Hedtec Ab, Mänkimiehentie 4 FIN-02780 Espoo Tel. : +3 58/9/68 28 81 Fax: +3 58/9/67 49 18 hedtec@hedtec. fi www. hedtec. fi N PANOS Lingonis + Sons O. [. . . ] The service lead (light fixture) is connected to the second neutral terminal (N) and phase (L'). Any green/yellow protective-earth conductors present must be secured to the clamp provided. Important: if the connections are reversed, this will cause a subsequent short circuit in the unit or your fuse box. In this case, the individual conductors must be reidentified and reinstalled. Examples of night economy mode: button button button Leuchte Light Wall mounting Warning: installation involves a mains connection. With 230 V, a risk of electrocution exists!Therefore, switch off the power first and check freedom from voltage with a voltage tester. Installation of the photoelectric lighting controller involves work on the mains power supply; this work must therefore be carried out professionally in accordance with regulations. Please note that the photoelectric lighting controller must be protected by a 10 A circuit breaker. The mains supply lead must be no greater than 10 mm in diameter. The NightMatic 3000 Vario can be installed directly ad6 jacent to the light fixture, if desired. A microprocessor distinguishes between the surrounding and consumer light, thereby ensuring constant light measurements. Switchless operation is recommended for optimum functioning. Using a screwdriver, loosen the four screws on the housing by turning anticlockwise and remove the housing cover. Hold the electronic housing against the wall and mark the drilling holes. Pay attention to the cable runs in the wall. During installation, ensure that the leads are always inserted from below if possible. [. . . ] Breakage due to a fall is also not covered. Further consequential damage to external items is excluded. Claims under warranty shall only be accepted if the product is sent fully assembled and well packed complete with sales slip or invoice (date of purchase and dealer's stamp) to the appropriate Service Centre or handed in to the dealer within the first 6 months. [. . . ]