User manual STIEBEL ELTRON SHU 5 SLI COMFORT

[. . . ] *) Please contact your local authority for further details. It means that used electrical and electronic products should not be mixed with general household waste. There is a separate collection system for these products. If your used electrical or electronic equipment has batteries or accumulators, please dispose of these separately beforehand according to local requirements. [. . . ] ⷠCondensation may form on the air outlet if the unit operates continuously in the COOL or DRY mode when humidity is over 80 percent. This air conditioner has a memory function to store settings when a power failure occurs. After power recovery, the unit will automatically re-start in the same settings which were active before the power failure, except for timer settings. If the timers were set before a power failure, they will need to be re-set after power recovery. In the HEAT operation, the indoor fan may not start for two to five minutes after the unit is turned on to prevent cold air from blowing out of the unit. When ice forms on the heat exchanger in the outdoor unit during the HEAT operation, an automatic de-icer provides heat for about 5 to 10 minutes to remove the ice. During de-icing, the inside and outside fans stop operating. ⷠAfter de-icing is completed, the unit automatically resumes operation in the HEAT mode. The unit employs a heat pump that draws heat from the outside air and releases it into the room. The outside air temperature therefore greatly affects the heating efficiency. ⷠIf the heating efficiency is reduced due to low outside temperatures, use an additional heater. ⷠThe unit can be affected by signals transmitted from the remote control of a television, VCR or other equipment used in the same room. ⷠDo not leave the remote control in direct sunlight or near a heater. Also, protect the unit and remote control from moisture and shock which can discolour or damage them. Example: 5 o'clock in the afternoon 1 To set to the 12-hour mode, press the CLOCK button once in the first step. To set to the 24-hour mode, press the CLOCK button twice in the first step. The current time cannot be set when the timer is operating. In the AUTO and DRY modes, the temperature can be C changed in 1°C increments within the range of 2°C higher (Example: 2°C lower) to 2°C lower from the temperature automatically determined C by the air conditioner. ⷠIn the COOL and HEAT modes, the temperature can be set within the range of 18 to 32°C In the DRY mode, the fan speed is preset to AUTO and cannot be changed. To turn off the unit, press the ON/OFF button again. In the AUTO mode, the temperature setting and mode are automatically selected according to the room temperature and outdoor temperature when the unit is turned on. During seasons when you need COOLING at daytime and HEATING at night, or if the room temperature should become extremely higher than the temperature setting, due to supplementary heating equipment, the mode will automatically switch between HEAT and COOL mode to keep the comfortable room temperature. [. . . ] You can use the ON and OFF timers in combination. And resume operation (With the same mode and temperature settings) to turn on the unit by 7:00 a. The arrow ( or ) between the TIMER ON indicator and the TIMER OFF indicator shows which timer will activate first. You cannot programme the ON-TIMER and OFF-TIMER to operate the unit at different temperatures or other settings. [. . . ]