User manual STOKKE IZI GO BY BESAFE

[. . . ] magnets can influence electronic equipment such as pacemakers. € The seat must always be replaced following an accident. Although it may look undamaged, in the event of another accident, it might not be able to protect your child as well as it should. € Prevent the seat from becoming trapped or weighed down by luggage, seats and/ or slamming doors. [. . . ] • Never leave the child unattended. WARNING EN 12790-2009 • Do not use the seat as reclined cradle once your child can sit unaided. € This seat is not intended for prolonged periods of sleeping. € It is dangerous to use this seat on an elevated surface. • Always use the restraint system. WARNING Stokke® iZi Go™ by BeSafe® UK 9 Introduction Do not use this product until you have thoroughly read and understood this user guide. Stokke® advises that child seats shall not be bought or sold second hand. Many seats sold through local advertising and car boot sales have been found to be dangerous. DO keep this user guide in the pocket of the seat. Fitting your child in the Stokke® iZi Go™ by BeSafe® . Using the Stokke® iZi Go™ by BeSafe® with a stroller from Stokke. 4 9 10 11 13 17 17 17 18 20 20 10 UK Stokke® iZi Go™ by BeSafe® Crucial parts Carrying handle Head rest Handle release buttons (2x) Shoulder straps (2x) Harness buckle Baby cushion Hip belt hook (2x) Crotch strap Cover Central adjuster Sun canopy Instruction label Stroller release handles (2x) Shoulder belt hook Harness height adjuster Stroller adapter house Stokke® iZi Go™ by BeSafe® UK 11 Installation in the car It is NOT ALLOWED to mount the seat in a front passenger seat WITH AN ACTIVATED AIRBAG. Make sure the carrying handle is in the carrying position. Guide the hip belt of the 3-point-belt over the blue parts through the hip belt hooks and fasten the seat belt with a ‘click’. Guide the shoulder belt over the blue part through the shoulder belt hook at the rear side of the seat shell. Tighten the 3-point belt by pulling the belt through the hip belt hooks and through the shoulder belt hook until it is really tight. Positioned in the back seat of the vehicle, you should push the front seat of the vehicle backwards, so that it is in contact with the child seat. Positioned in the front seat , you should push the front seat forwards, so that the child seat is in contact with the dashboard. If this is not possible, leave a space of minimum 25 cm between child seat and back rest of the front seat or dashboard. Stokke® iZi Go™ by BeSafe® UK 13 Fitting your child in the Stokke® iZi Go™ by BeSafe® • To position your child, you can fold the carrying handle behind the seat in 2 positions, by pressing both handle release buttons. € Position the shoulder straps: Check that the shoulder strap slots are levelled with your child's shoulders. Too high too low correct 14 UK Stokke® iZi Go™ by BeSafe® • The height of the shoulder straps can be adjusted by pulling the harness height adjuster out and moving the adjuster up or down. [. . . ] € Sørg for, at både 3-punktsselen og barnets sikkerhedssele er spændt ordentligt fast for at undgå, at barnet eller stolen sidder forkeret. € Sørg altid for, at stolen er fastgjort korrekt, når den bruges på en barnevogn fra Stokke. hvis den ikke fastgøres korrekt , kan dit barn komme til skade eller dø. € Når stolen er fastgjort til stellet på en barnevogn fra Stokke, må du aldrig bruge stolen til at løfte vogn og stol. [. . . ]