User manual STRONG SRT 700 BROCHURE

[. . . ] Never put a heavy object on the power cord or wrap it around the leg of a table or chair. Keep the area around the power cord connection points, at the power outlet, and at the product connection, free of all AC adapter or accessory power cords n CAUTION: TO REDUCE THE RISK OF ELECTRICAL SHOCK, DO NOT REMOVE COVER (OR BACK). REFER TO QUALIFIED SERVICE FOR SERVICING. Explanation of WARNING symbols The lightning flash with arrowhead symbol within an equilateral triangle is intended to alert the user to the presence of not isolated dangerous voltage within the inside of the product that may be of sufficient magnitude to constitute a risk of electric shock to persons. The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and servicing instructions in the literature accompanying the appliance. [. . . ] You will be asked to confirm operation. 5. 1. 2 Favourites Manager Press the UP/DOWN keys to select the channel. Press the LEFT/RIGHT keys to point the focus to the favourite group. Press the OK button to add the selected channel to the Favourite group. To remove the channel from the favourite group, repeat same operation. 5. 2 Installation The installation menu contains three sub-menus; "Antenna Installation", "Auto Scan" and "Manual Scan". 10 PART 1 · English 5. 2. 1 Antenna Installation You can add a satellite, edit a satellite and delete a satellite in this menu. Add satellite If you want add a new satellite, press the RED key in this menu, a satellite list will appear on the screen. Press RIGHT/LEFT to select the satellite. If the satellite does not exist in the satellite list, please select "NEW SAT1". After selection of a satellite from the satellite list, the Configure Antenna menu will appear, please set the LNB Type, LNB Low Freq, LNB High Freq, Band control, Polarisation control, DiSEqC Switch and Antenna mode. Further steps of installation are described in 4. 2. Edit satellite If the parameters of the satellite were changed or the satellite is a new satellite, you must set the parameters of the satellite, such as LNB type, LNB low Freq, LNB High Freq, Transponder, LNB Power, 22k Tone, DiSEqC and Antenna Mode. Sequence of editing of satellite parameters is same as sequence of "Add satellite" described in 4. 2 Delete satellite If you want to delete a satellite, press the YELLOW key. If you don't know which standard your TV has, please select AUTO. n Screen mode In TV format Screen press OK or RIGHT to select 4:3 or 16:9, press OK to confirm. n Video output In Video output Screen press OK or RIGHT to select CVBS or RGB, press OK to confirm. n Modulator settings Use UP/DOWN to select RF Audio mode or RF channel. Use LEFT/RIGHT to change the settings and press OK to confirm the settings or EXIT to cancel. 5. 3. 1. 3 Time Settings If a broadcaster provides GMT, you can set the time using GMT, or set your own time by yourself. If the GMT usage is ON then you have to set the Time Zone. If you set GMT Usage to OFF, Set Data and Set Time item are displayed. To set the time value manually, move the cursor to the time item and use the numeric buttons on the remote control. 5. 3. 1. 4 Set Factory Default Please be careful when using this function, because it will erase all the data and parameters you may have set earlier to your receiver. Once you set the factory default you will have to re-install your preferences and re-scan your channels. To reset your receiver to factory default, apply the following steps: 12 PART 1 · English Select Set Factory default and press OK. Confirm warning message with OK and press the OK key, the receiver will return to its factory default state, and all user data will be deleted. [. . . ] A dish antenna that is aimed at one particular satellite. Unscrambled broadcast which you can view for free 11 ~ 13 GHz Frequency. The LNB is an electronic unit mounted on the satellite dish. It receives the signals reflected by the dish and converts them to signals that can be used by Satellite receiver. [. . . ]