User manual STRONG SRT 8410

[. . . ] Digital Terrestrial Receiver with Embedded Viaccess SRT 8410 User manual Safety Instructions SAFETY INSTRUCTIONS Grounding, Polarization -- If this product is used with a specified AC adapter, the adaptermay be equipped with a polarized alternating current line plug (a plug with one blade wider than the other). This safety feature allows the plug to fit into the power outlet only one way. If you cannot insert the plug into the wall outlet, pull it out, reverse it, and then reinsert it. If the plug still fails to fit, contact an electrician and have the receptacle replaced n Protecting the Power Cord -- The power supply cord should be placed so it will not bewalked on. [. . . ] The grounding system must comply with SABS 061. NOTE: Dispose the used batteries at designated place for environment protection 5 2. 0 INTRODUCTION 2. 1 Front Panel 1. Display I In ON mode channel number is shown 2. 2 Rear Panel 1. ANT IN To connect your terrestrial antenna 2. TO TV If you want your antenna signals from "ANT IN" connector inject to second receiver or TV set. Use this loop trough output "TO TV" to connect these by using a coaxial cable. HDMI Use this connection to connect the receiver to your TV using HDMI cable. S/PDIF Digital audio output Use this coaxial output to connect your receiver to the input of your digital audio amplifier. AUDIO Right (Red RCA) and Left (White RCA) These connectors give you the possibility to connect the audio signal to an external amplifier or to the audio input of your TV. TV SCART Connector Use this connector to connect your receiver with your TV set using a SCART cable. Main power switch 2. 3 Remote control Remove the battery compartment cover and load two AAA (UM-4 or R03) batteries. Make sure that the batteries have been inserted in the correct polarities matching to the symbols +, - marked in the battery compartment. If replacing of batteries is necessary, replace both 6 batteries. Do not mix new and used batteries otherwise the operation lifetime will be much shorter than normal. Remove the batteries if the unit will not be used for a prolonged period of time. The remote control transmits a directional infrared beam. Be sure to aim the remote control directly at the infrared sensor of the unit during operation. If the sensor has been covered, the sensor will not respond. The sensor may not able to receive the remote signal when it is exposed to direct sunlight or a strong artificial light (fluorescent or strobe light). In this case, change the direction of the light or reposition the unit to avoid direct lighting. BE ENVIRONMENTALLY FRIENDLY Do not dispose batteries as normal rubbish. Please dispose batteries following the Government's regulation. [. . . ] In consequence of continuous research and development technical specifications, design and appearance of products may change. Viaccess is a trademark of France Telecom all other product names are trademarks or registered trademarks of their respective owners. 01/2009 NOTE: Design and Specifications may be changed without warning. Weight and dimensions are approximate. 16 A. 1 TROUBLESHOOTING In some regions, the digital terrestrial signal may be weak. [. . . ]