User manual STRONG SRT 7504

[. . . ] Digital high Definition satellite Receiver sRT 7504 návod k obsluze Používateľská príručka User manual USB Recording 4000 Channels 20 Timers Subtitles Picture similar Obr. 1 1 2 3 4 5 Smartcard (Čipem dolů) Obr. 5 3 4 6 7 9 11 12 11 14 16 18 20 21 24 25 27 28 20 21 5 8 10 12 13 15 17 19 22 23 26 29 22 23 1. 2. 3. Obr. 6 Satelitní anténa Koaxiální kabel HDMI kabel SCART kabel 100-240 V~ / 12 V Obr. [. . . ] Network Search  scanning the selected satellite. NIT 18 Fast scan:  rescan the channel list supplied by the operator that you have chosen. Will Fast Scan is only available on Astra 23. 5E. When all settings have been made, press OK at the preferred scan method to start this scan process or to quit without scanning. All newly found channels will be stored at the end of the channel list. *Only available if more than one satellite has been setup. Note  (Network Identification Table): This option will scan on the NIT table of NIT the satellite and allows you to receive new appeared channels. English Note  When you want to add technical data for a new transponder we recommend verifying it by consulting websites like: www. lyngsat. com or www. kingofsat. net or you can refer to professional journals. 7. 1. 3 System Settings Use the System Settings menu to configure settings for language, audio, video, look and feel of your receiver. Choose a setting with pq and press OK to list the possibilities or use tu to change the value of the highlighted setting. Please also read the displayed instructions for each screen carefully. They will help you to adjust the settings correctly and easily. Language:  Here you can change the language for the On-Screen-Display, use tu to select your preferred language. It affects the menu language of your receiver so all menus and messages will be displayed in the chosen language. Video Setting: S  elect the connection to your TV set. Either Scart or HDMI can be selected via tu. Press OK at the used connection to open the settings for it. For details, see chapter 7. 1. 3. 1 HDMI or 7. 1. 3. 2 SCART. Audio Output:  Here you can adjust the settings for your digital audio output. Press tu to choose between BitStream and PCM. If a device that can decode Dolby® Digital is connected, use the setting BitStream. Audio language: Press OK to open the setting. The most important audio languages are displayed. For details, see chapter 7. 1. 3. 3 Select Audio Language. Subtitle Setting Press OK to open this setting. For details, see chapter 7. 1. 3. 4 Select Subtitle Language Start up channel  this menu you can select your start up channel. [. . . ] Trees grow between the dish and satellite position (the sky must be 100% clear) Set the values of the tuner parameters correctly in the menu Installation -- Antenna Setup/Channel Search. Helpful websites are: http://de. kingofsat. net/ http://www. lyngsat. com/ Macroblockings/ audio video interruptions No picture Message “No signal”. The receiver can’t receive the signal. Incorrect values of some tuner parameters. 30 No access to scrambled services Expired subscription. No subscription for the selected channel. The card is wrongly inserted Insert the smart card with the golden chip down and forwards into the reader slot. Insert the correct smart card type or check with the operator if the smart card married function is switch on. [. . . ]