User manual STUV 30-IN

[. . . ] We strongly recommend that you entrust the installation of your Stûv to (or at least have the installation checked by) a qualified professional who can, in particular, make sure that the specifications of the flue correspond to the fireplace installed. With the fireplace, you should receive : ­ a paint spray for repairs ­ a "cold" handgrip for manoeuvring the doors, the damper, and the drum ­ 2 finishing frames ­ the front fixing part ­ the front ­ the fireplace's upper plate ­ documents : certificate of guarantee (to be returned to Concept & Forme) installation instructions directions for use final inspection card for the fireplace. Check that the windows have not been broken during delivery. The guarantee only covers damage due to transport if it is notified within 48 hours of delivery. [. . . ] Make it airtight by filling the space between the pipe and the flange. Note : once the fireplace is in its final position, don't forget to remove the transport and positioning bracket (photo 25). We strongly recommend that you connect these, if you are not using a ventilator to distribute the hot air. Remove the precut parts by tapping as closely as possible to the smoke outlet, and then screw in the flanges (photos 26 & 27). Using M5 screws, put in place the front fixing part (page 30). Put back the upper halfdisk, and screw it on, using the No. 36 Place the four levels of vertical refractories from left to right; cover the bottom of the fireplace with the five remaining refractories. 37, 38 and 39 It is easy to position the deflector on the refractories, thanks to the lugs, which perfectly match their shape. De ventilator in de opening van de aslade steken, de kabels door de opening rechts onderaan trekken (fig. Check that the delivery does in fact include the following items (photo 44): ­ 1 ventilator, ­ 2 foamrubber seals, ­ 1 "switch" housing, ­ 2 M5x8 fixing screws for the "switch" housing. Before carrying out any electrical work, disconnect the power supply!Using the 8mm box spanner, remove the 2 screws from the ventilator access hatch panel (photo 48). Stick the 2 foamrubber seals on either side of the circular hole, perpendicular to the back wall, in such a way that the ventilator can be put in place (photo 50). First of all, remove any grease from around the circular hole. Position the ventilator in the ashpan space, and pass the cables through the hole (Figure 52A) at the back on the right (photo 51). Push the ventilator to the back of its recess. Rotate it a few degrees so that it fits snugly into the recess (Figure 52). Take hold of the 3 Faston plugs emerging from the ventilator. Insert the "switch" casing, with the speed regulator uppermost (photo 55). attach the "switch" casing (photo 55). Reconnect the power supply, and test the ventilator's operation in all three positions. You have chosen a Stûv fireplace ; Concept & Forme thanks you for doing so. [. . . ] Stûv fireplaces are designed for domestic use, and certainly not for the incineration of waste of any kind. Respect the rated power of the fireplace (11 kW = ± 3 kg of dry wood per hour). First of all, set balls of paper and kindling on fire. Open the damper (photo 8) as far as possible and leave the door ajar (photo 10) if you are in the glassdoor position to avoid smoke fumes condensing on the cold window and leaving a soot deposit. [. . . ]