User manual SUB-ZERO 245-PS

[. . . ] Planning Information Undercounter Model 245 Refrigerator / Freezer Adjustable refrigerator control Interchangeable door hinge Stationary glass shelves Serial and model number plate Automatic ice maker Model 245 Removable ice bucket Stationary door shelves Interior freezer light Front venting with removable kickplate Adjustable freezer control from the full-size units Sub-Zero offers in its Built-In and Integrated lines of refrigeration, we round out our product line-up with a line of traditional Undercounter refrigeration which meets all of the exacting standards you have grown to expect from Sub-Zero. This beautifully crafted undercounter refrigerator / freezer is a must for that special bar area in the home. [. . . ] For Model 245 with automatic ice maker, rough in the water supply line. Connect a 1/4" OD copper line to the house supply, being sure to use an easily accessible shut off valve between the supply and the unit. A saddle valve kit (4200880) is available from your Sub-Zero dealer. To obtain local dealer information, visit the Locator section of our website, subzero. com. A line filter is required when water conditions have a high sediment content. The ice maker operates on water pressure of 20 psi (1. 4 bar) to 100 psi (6. 9 bar). In some cases a reverse osmosis water filter system may not be able to maintain the minimum water pressure consistently. A 115 V AC, 60 Hz, 15 amp fused electrical supply is required. It is recommended that a separate circuit, serving only this appliance, be provided. All Undercounter models are equipped with a power supply cord with a 3-prong grounding plug which must be plugged into a mating 3-prong grounding type wall receptacle. Locate electrical within the shaded area shown in the illustration on page 3. You must follow all National Electrical Code regulations. In addition, be aware of local codes and ordinances when installing your service. [. . . ] Refer to the full-scale illustration on pge 6. The overlay door panel design application is not available for the Model 245. Trim reveal 1/4" (6) min 1/4" (6) Panel Framed door panel 1/4" (6) thick or less IMPORTANT NOTE: The weight of the panel cannot exceed 20 lbs (9 kg). PANELS THICKER THAN 1/4" (6) Trim reveal 1/4" (6) min Rout to 1/4" (6) thickness F R A M E D PA N E L D I M E N S I O N S Door Panel Width Door Panel Height Maximum Panel Weight 23 1/2" (597) 28 1/8" (714) 20 lbs (9 kg) Framed door panel thicker than 1/4" (6) H W Framed Door Panel Dimensions in parentheses are in millimeters unless otherwise specified. 5 Planning Information Undercounter Model 245 MODEL 245 ­ LOWER HINGE TOP VIEW 237/8" (606) WIDTH OF UNIT BOTTOM HINGE EXTENDS 1/4" (6) FROM SIDE OF UNIT UP TO 31/2" (89) FROM FLOOR DOOR 233/4" (603) TO BACK OF UNIT Dimensions in parentheses are in millimeters unless otherwise specified. 6 [. . . ]