User manual SUB-ZERO PRO 48 INSTALLATION REV A 10-2010

[. . . ] INSTALLATION GUIDE PRO 48 Refrigeration Contents PRO 48 Refrigeration . 18 Features and specifications are subject to change at any time without notice. Visit subzero. com/specs for the most up-todate information. IMPORTANT NOTE: Throughout this guide, dimensions in parentheses are millimeters unless otherwise specified. Important Note To ensure the safe and efficient installation of Sub-Zero equipment, please take note of the following types of highlighted information throughout this guide: IMPORTANT NOTE highlights information that is especially relevant to a problem-free installation. [. . . ] The cable ties should be replaced with the extra cable ties provided, once the unit is properly installed. Remove the three grille bolts from base of the grille and the upper grille screw. Reverse this procedure to reinstall the grille assembly. Retract the front leveling legs all the way up to allow the unit to be moved into position more easily. You will extend the front leveling legs down and make adjustments once the unit is in position. Allow 24 hours for proper ice production. IMPORTANT NOTE: Water lines must not be exposed to freezing temperatures. Exposure could cause damage to the unit and home. Level the Unit Once the unit is in position, extend the front leveling legs down by turning the legs counterclockwise and adjust the height. The rear height adjustment can be made from the front of the base. Use a 5/16" socket to adjust the rear rollers. Turn the 5/16" hex bolt clockwise to raise the unit or counterclockwise to lower it. Refer to the illustration below for location of the rear roller base adjustment. When the unit is properly leveled, door and drawer adjustments are less likely to be necessary. IMPORTANT NOTE: Be sure to reference leveling of the unit to the floor and not surrounding cabinetry. This could affect the operation of the unit, such as door closing. To reduce the possibility of the unit tipping forward, the front leveling legs must be in contact with the floor. REAR ADJUSTMENT FRONT LEVELING LEG Rear roller base adjustment. PRO 48 Installation 13 subzero. com/specs Door Adjustment Make sure both doors of the PRO 48 are properly aligned for function and appearance. If not, adjustments can be made to the cabinet hinges. IMPORTANT NOTE: The unit must be properly leveled before adjusting hinges. The doors of the PRO 48 are very heavy. Use care when removing them. If the PRO 48 is properly installed and leveled, it may still be necessary to adjust doors left to right. Adjustments are performed at the top and/or bottom cabinet hinges. HINGE ADJUSTMENT 1) Lift up the vent portion of the top grille. 2) Remove the door by opening to approximately 90° and lifting the door off cabinet hinges. 4) Loosen the two cabinet hinge screws 1/4 to 1/2 turn. With the door open, using the Allen wrench provided, turn the adjustment screw to adjust the cabinet hinge. If additional adjustment is required, repeat these steps until the door is properly aligned. IMPORTANT NOTE: When adjusting hinges, it is important to keep hinges parallel to the face of the door and side of the cabinet. Excessive misalignment will result in door light switch malfunction. If the switch is not activated, the fan will not operate and lights will remain on. [. . . ] Has the anti-tip bracket been installed securely and properly engaging the unit?Is the unit leveled properly on a solid, level floor?Has the drain pan and kickplate been installed?Has the top grille assembly been reinstalled? [. . . ]