User manual SUB-ZERO W662418

[. . . ] Pro wall hoods are sold as a shell only; internal, in-line and remote blower options are available Wolf Pro wall hoods provide the ultimate in ventilation. With standard elements like heat sentry and dual setting halogen lighting, Wolf elevates the need for ventilation to an enjoyable perk. Pro 24" (610) deep wall hoods are available in the classic stainless steel finish. You also have the option of a decorative rail. [. . . ] Wolf Pro wall hoods are shipped without a blower assembly. Internal, in-line and remote blower assemblies are available. Blower options also vary with the volume of air that needs to be moved and the length of the duct run. Refer to the end of this section for Pro ventilation recommendations and blower options. IMPORTANT NOTE: Install this ventilation hood only with a Wolf blower. Pro wall hoods require a separate, grounded 110/120 V AC, 60 Hz power supply. The service should have its own 15 amp circuit breaker. Placement of the electrical supply is not critical, as long as you provide a minimum of 6" (152) of 120 V AC, 60 Hz power cable. Locate electrical within the shaded area shown in the Installation illustration. Note that the location of the electrical supply will differ between vertical and horizontal discharge blowers. You must follow all National Electrical Code regulations. In addition, be aware of local codes and ordinances when installing your service. Refer to the installation instructions shipped with each Wolf product for detailed specifications. This information can also be found on our website, wolfappliance. com. Dimensions in parentheses are in millimeters unless otherwise specified. 5 Planning Information Model W662418 (R) Pro Wall Hood D U C T I N G C O N S I D E R AT I O N S Wolf Pro 24" (610) deep wall hoods are shipped without the blower assembly. Internal, in-line or remote blower assemblies are available. The remote blower can be mounted on the roof or an exterior wall. Refer to the illustration below for ducting options. Pro 24" (610) deep wall hoods have an adjustable discharge location that can run vertically or horizontally. Horizontal discharge is applicable on 24" (610) deep hoods used with WBLOWER60INT or WBLOWER-120INT or any remote blower. WBLOWER-90INT is not for use in horizontal discharge applications. Refer to the Pro ventilation charts at the end of this section for recommendations and blower options. DUCTWORK INSTALLATION THROUGH ROOF Ducting considerations for Pro 24" (610) deep wall hoods. ROOF CAP OR REMOTE BLOWER 10" ROUND DUCT TRANSITION 22 1/4"W x 9"D TO 10" ROUND 10"H (INCLUDING FLANGES) SOFIT OR CABINET OR DUCT COVER VERTICAL DISCHARGE 18" (457) HEIGHT OF HOOD WALL HOOD WALL CAP OR REMOTE BLOWER DUCTWORK INSTALLATION THROUGH WALL DISCHARGE COLLAR 24" (610) DEPTH OF HOOD 30" TO 36" (762­914) COUNTERTOP TO BOTTOM OF VENTILATION HOOD HORIZONTAL DISCHARGE* 36" (914) STANDARD FLOOR TO COUNTERTOP HEIGHT *HORIZONTAL DISCHARGE IS APPLICABLE ON 24" (610) DEEP WALL HOODS USED WITH WBLOWER-60INT, WBLOWER-120INT OR ANY WOLF REMOTE BLOWER. WBLOWER-90INT IS NOT FOR USE IN HORIZONTAL DISCHARGE APPLICATIONS. Dimensions in parentheses are in millimeters unless otherwise specified. 6 Planning Information Wolf Ventilation Recommendations WOLF BLOWER ASSEMBLIES A ventilation system must include a blower assembly. [. . . ] Model numbers for dual fuel ranges, gas ranges, sealed burner rangetops and gas rangetops indicate width and number of surface burners. Features such as a charbroiler, griddle and/or French Top will vary. CFM recommendations are based on total Btu/hr output. Wolf recommends 1 CFM per 100 Btu/hr (. 03 kW). [. . . ]