User manual SUNBEAM 2631-33

[. . . ] JCS shall not be liable for any incidental or consequential damages caused by the breach of any express, implied or statutory warranty or condition. Except to the extent prohibited by applicable law, any implied warranty or condition of merchantability or fitness for a particular purpose is limited in duration to the duration of the above warranty. jCS disclaims all other warranties , conditions or representations , express , implied , statutory or otherwise. JCS shall not be liable for any damages of any kind resulting from the purchase, use or misuse of, or inability to use the product including incidental, special, consequential or similar damages or loss of profits, or for any breach of contract, fundamental or otherwise, or for any claim brought against purchaser by any other party. [. . . ] Never yank cord to disconnect from outlet; instead, grasp plug and pull to disconnect. ⷠDo not allow cord to touch hot surfaces. let iron cool completely before putting away. Loop cord loosely around iron when storing. ⷠAlways disconnect iron from electrical outlet when filling with water or emptying and when not in use. ⷠDo not operate iron with a damaged cord or if the iron has been dropped or damaged. To avoid the risk of electric shock, do not disassemble the iron. Take it to an authorized service center for examination and/or repair. Incorrect reassembly can cause a risk of electric shock when the iron is used. ⷠClose supervision is necessary for any appliance being used by or near children. Do not leave iron unattended while plugged in or turned on or on an ironing board. ⷠBurns can occur from touching hot metal parts, hot water or steam. Use caution when you turn a steam iron upside down ­ there may be hot water in the reservoir. ⷠIf the iron is not operating normally, disconnect from the power supply and have the iron serviced by an authorized service center. Do not set the iron on an unprotected surface, even if it is on its heel rest. Make sure the Steam Switch is turned to the (Dry) setting. Select the temperature setting you desire using the dial. While the iron is heating, make sure it is sitting on its heel rest on a stable, protected surface. Clean the soleplate if starch or other residue accumulate. TO CLEAN THE SOLEPLATE: Turn off and allow the iron to cool and then wipe it with a soft, damp cloth. [. . . ] WARNING: NEVER yank the power cord when unplugging the iron. If you do not use your iron on a daily basis, empty the water reservoir after each use for a longer iron life. To do so, unplug the iron, turn the iron upside down, open the fill hole cover, and allow water to flow from the fill hole. Loosely loop the power cord around the iron body and store the iron on its heel rest. [. . . ]