User manual SUNBEAM 3138

[. . . ] This appliance has a polarized plug (one blade is wider than the other). To reduce the risk of electric shock, this plug is intended to fit in a polarized outlet only one way. If the plug does not fully fit in the outlet, reverse the plug. [. . . ] Never immerse the motor housing in water. Removing the Lid litter: Lift up to slide out as pictured (E). Removing the Cutting Unit: Raise can opener lever to its fullest upright position. Push can opener lever to the right to remove it from the recessed area (F). Drive Wheel Wipe off drive wheel with a damp cloth. To thoroughly clean drive wheel, use small brush to remove accumulated dirt (G). Replacing the Cutting Unit With can opener lever in raised position, place knob in recessed area. Push lever to the left to snap it into position (H). Replace the lid lifter Twist the knob to raise and lower the cutting assembly. To adjust the height of the cutting assembly follow these directions: 1. Twist the knob in a counter-clockwise direction until the knob clicks into place. The cutting assembly Is raised for opening extra tall cans. Twist the knob in a clockwise direction to lower the cutting assembly for opening regular size cans and for compact storage. The motor and internal gears of your can opener unit are permanently lubricated at the factory for lifetime service and require no further attention. The cutting blade is made of hardened steel and is a special design. It will last for years under normal use. [. . . ] Continue this process until the desired sharpness is achieved. SCiSSOrJ: Press down on the can opener lever to start the grinding wheel. Open scissors, hold blade to be sharpened with the other blade on the bottom. Pull blade through slot from left to right (Jj. [. . . ]