User manual SUNBEAM 4239

[. . . ] Do NOT attempt to repair or adjust any electrical or mechanical functions on this product. This warranty is valid for the original retail purchaser from the date of initial retail purchase and is not transferable. JCS dealers, service centers, or retail stores selling JCS products do not have the right to alter, modify or any way change the terms and conditions of this warranty. This warranty does not cover normal wear of parts or damage resulting from any of the following: negligent use or misuse of the product, use on improper voltage or current, use contrary to the operating instructions, disassembly, repair or alteration by anyone other than JCS or an authorized JCS service center. [. . . ] If you have any other problem or claim in connection with this product, please write our Consumer Service Department. Do not leave iron unattended while plugged in or turned on or on an ironing board. If the iron is not operating normally, disconnect from the power supply and have the iron serviced by an authorized service center. Burns can occur from touching hot metal parts, hot water or steam. Use caution when you turn a steam iron upside down ­ there may be hot water in the reservoir. Do not set the iron on an unprotected surface, even if it is on its heel rest. Fill water cup with tap water and pour water into iron water reservoir. Do not fill water reservoir beyond maximum fill level. WARNING: To prevent the risk of burns, be careful when filling a hot iron with water. Hot metal parts, hot water and steam can cause injuries. Make sure the Steam Lever is turned to the (Dry) setting. then move the Variable Steam Lever to (Dry) and the Fabric Select Slider to Off. WARNING: The Auto-Off is a safety feature and is not a recommended means for turning your iron off. see "Caring for Your Iron After Use. " MOTION SMART AUTO-OFF FEATURE (select models only) When the iron is plugged in, the Power Indicator will light steadily, indicating that there is power to the iron. In a horizontal position without moving it, or accidentally tip the iron over, it will automatically stop heating after 30 seconds. The Power Indicator will blink to let you know that the iron has stopped heating. ⷠIn a vertical position (on its heel rest) without moving it, the iron will automatically turn off after 15 minutes. The Power Indicator will blink to let you know that the iron has stopped heating. iMPORTANT: The Power Indicator will continue to blink until the iron is unplugged or reset. TO RESET THE IRON: Move the iron back and forth and allow it to reheat for 2 minutes. the indicator will stop blinking and the iron will start heating again. [. . . ] Hold the iron with one hand and use the other hand to grab the end of the cord. In case cord is not fully rewound, pull out the cord and steer cord evenly on the reel. In case the cord is not pulled out easily, pull cord firmly. Do not allow children to use retractable cord feature as the cord may cause injury. [. . . ]