User manual SUNBEAM BLSBX-3350W-033

[. . . ] When blending hot liquids, remove center piece of two-piece cover. Do not fill blender container beyond 3-cup level. Always begin processing at the lowest speed setting. Keep hands and other exposed skin away from the cover opening to prevent possible burns. [. . . ] Important: Your blender jar and cutting blades are subject to wear during normal use. Always inspect cutting blades for broken, cracked or loose blades. If jar or cutting blades are damaged, do not use. Call our toll-free customer service number to obtain replacement parts. Place blender base on clean, dry surface to keep foreign particles from being pulled up into motor during operation. Before inserting blade assembly/skirt, be sure that the gasket is seated around blade base. To remove jar after blending is complete, hold blender base with one hand, grasp skirt and jar with the other hand and twist both skirt and jar together, counterclockwise approximately a quarter turn to unlock, then lift jar straight up from base. Always turn blender OFF and wait until blades have stopped rotating before removing jar or lid. Put ingredients in jar, place lid with filler cap in place on jar making sure it is pushed down completely into position. Set skirt into place on blender base, making sure it is securely seated by twisting jar clockwise until it snaps into the locked position. You may not hear an audible snapping sound, but will feel it lock into place. Never run without jar Never place jar onto unit while motor is running. This means it operates only while the button is held down. All other speeds are continuous cycle operation. They operate continuously at whatever speed is selected until the "Off" button is pressed. Pulse speed is same as "Smoothie", which is maximum speed. Press "Pulse" button and hold down for about 2 seconds. Release "Pulse" button and allow blades to coast to a stop. Repeat cycles until contents reach desired consistency. Release of the "Pulse" button turns blender off. Note: "Pulse" button can be held longer than 2 seconds as needed. Press desired speed button to turn blender on. [. . . ] This warranty does not cover normal wear of parts or damage resulting from any of the following: negligent use or misuse of the product, use on improper voltage or current, use contrary to the operating instructions, disassembly, repair or alteration by anyone other than JCS or an authorized JCS service center. Further, the warranty does not cover: Acts of God, such as fire, flood, hurricanes and tornadoes. This warranty is valid for the original retail purchaser from the date of initial retail purchase and is not transferable. JCS dealers, service centers, or retail stores selling JCS products do not have the right to alter, modify or any way change the terms and conditions of this warranty. [. . . ]