User manual SUNBEAM GCSBDG

[. . . ] Some provinces, states or jurisdictions do not allow the exclusion or limitation of incidental or consequential damages or limitations on how long an implied warranty lasts, so the above limitations or exclusion may not apply to you. This warranty gives you specific legal rights, and you may also have other rights that vary from province to province, state to state or jurisdiction to jurisdiction. If you have any question regarding this warranty or would like to obtain warranty service, please call 1 800 458-8407 and a convenient service center address will be provided to you. In Canada If you have any question regarding this warranty or would like to obtain warranty service, please call 1 800 667-8623and a convenient service center address will be provided to you. [. . . ] Do not leave iron unattended while plugged in or turned on or on an ironing board. Do not operate iron with a damaged cord or if the iron has been dropped or damaged. To avoid the risk of electric shock, do not disassemble the iron. Take it to an authorized service center for examination and/or repair. Incorrect reassembly can cause a risk of electric shock when the iron is used. Always disconnect iron from electrical outlet when filling with water, cleaning or emptying and when not in use. Do not allow cord to touch hot surfaces. let iron cool completely before putting away. Loop cord loosely around iron when storing. The Fabric Select Dial and Steam Lever should always be turned to OFF before plugging or unplugging from outlet. Never yank cord to disconnect from outlet; instead, grasp plug and pull to disconnect. Run the iron over an all-cotton cloth to remove any residue. USING THE SELF-CLEANING FEATURE: You should use the Self-Cleaning feature once a month to maintain the optimal performance of your iron. TO USE THE SELF-CLEANING FEATURE: Turn off iron following instructions above. Fill the water reservoir with tap water to the MAX line. Plug in the iron, set the Fabric Select Dial to Linen and allow the iron to heat for 2 minutes. WARNING: Be careful not to touch the iron's hot surfaces. Slowly rock the iron side to side and front to back for 30 seconds. When rocking the iron, dip the nose of the iron slightly below the rear of the iron to make certain the water circulates completely. Release the Self-clean Button after one minute. Open the fill cap, turn the iron upside down, and allow the remaining water to flow out of the fill hole. Let the iron heat for 2 minutes to dry out the iron completely. [. . . ] WARNING: The Auto-Off is a safety feature and is not a recommended means for turning your iron off. When the iron is plugged in, the Power Indicator will light steadily, indicating that there is power to the iron. yOU LEAVE THE IRON: · In a horizontal position without moving it, or accidentally tip the iron over, it will automatically stop heating after 30 seconds. The Power Indicator will blink to let you know that the iron has stopped heating. [. . . ]