User manual SUNBEAM GCSBSP3057

[. . . ] Doing business as Jarden Consumer Solutions or if in Canada, Sunbeam Corporation (Canada) Limited doing business as Jarden Consumer Solutions (collectively "JCS") warrants that for a period of one year from the date of purchase, this product will be free from defects in material and workmanship. JCS, at its option, will repair or replace this product or any component of the product found to be defective during the warranty period. Replacement will be made with a new or remanufactured product or component. If the product is no longer available, replacement may be made with a similar product of equal or greater value. [. . . ] Mainly dry iron; steam may be used under garment manufacturer's instructions. Always read garment labels and follow the manufacturer's ironing instructions. You should first iron garments requiring low temperature (e. , silks and synthetics) to avoid damaging them with an iron that is too hot. ⷠIf you are unsure of the fabric content of the garment, test a small area, such as a seam or facing, before ironing a visible area. Start with a low temperature and gradually increase the heat to find the best setting. ⷠWhen changing the temperature from a high setting to a low setting, allow approximately 5 minutes for the lower temperature to be reached. ⷠWhen steam ironing, use long, slow passes over the fabric. This will allow the steam to penetrate the fabric while allowing the heat of the soleplate to dry out the moisture. ⷠTo iron linens, turn garment inside out. Be careful not to use an iron that is too hot because the lining may melt or stick to the soleplate. ⷠTo iron zippers, use an ironing cloth or make sure the zipper is closed and iron over the flap. Use the Ironing Guide to select the best setting and method for the fabric you plan to iron. ⷠSUNBEAM® irons are designed to be used with ordinary tap water. In areas where hard water exists, Sunbeam recommends running one to two iron water tanks full of distilled water every month. Using distilled water on a monthly basis will help to prevent mineral build up. cAUTION: Do not overuse distilled water. It may cause the iron to drip or spit if it is used too often. In a vertical position (on its heel rest) without moving it, the iron will automatically turn off after 15 minutes. The Power Indicator will blink to let you know that the iron has stopped heating. Move the iron back and forth and allow it to reheat for 2 minutes. Do not fill water reservoir beyond maximum fill level. [. . . ] The SHOT OF STEAM® feature may be used continuously in approximately 3 second intervals. WARNING: DO NOT use abrasive cleansers, scouring pads or vinegar to clean the soleplate. Run the iron over an all-cotton cloth to remove any residue. TIP: When using the vertical steam on clothing, hang the clothing on a clothes hanger for best results. [. . . ]