User manual SUNBEAM KY-25/Y

[. . . ] Your safety and the safety of others are very important. We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety messages. This symbol alerts you to potential hazards that can kill or hurt you and others. [. . . ] F) Place the window kit in the window or sliding door. Close the window or door as far as it goes. G) Adjust the length of exhaust duct and affix the window kit adapter onto the holes on the window kit. NOTE: When using the window kit on a window or sliding door it will cause the window or sliding door to not be properly closed and/or locked. Additional security measurements should be taken. A) You do not need to use window kit adapter. 22cm in diameter in the wall; attach the other end to the back of the unit (same as above). B) Use the exhaust outlet wall covers to cover the holes in the wall when the unit is not in use. The supplied exhaust hose can extend from 5. Take care to prevent any kind of bend in the middle of the exhaust hose, as this will trap hot exhaust air, which will radiate back into the room and affect the cooling function of the unit (Fig. The length of the exhaust pipe is specially designed according to the specification of this product. Do not replace or extend it with your own hose as this could cause the unit to malfunction (Fig. C) After installing the ducts, plug in the unit and turn the unit on. If the unit is turned off during operation please wait at least three minutes before starting it again. "Up" or "Down": Temperature or Time Changing Button: Use these two buttons to set to your desired temperature. the temperature unit can be on Fahrenheit or Centigrade. Press the ON/OFF Button for more than 20 seconds, then release. The temperature unit will be changed from Fahrenheit to Centigrade or vice versa. During the timer set-up, these buttons are also used to change the time. timer Setting or Cancel Button: Use to set or cancel TIMER-ON or TIMER-OFF timer. When the unit is on, the unit can be set with Timer-OFF. When the unit is off, the unit can be set with Timer-ON. [. . . ] Transportation charges on parts submitted for repair or refund, under this warranty, must be borne by the purchaser. SE/EG warrants that from the date of purchase, this product will be free from mechanical defects for a period of one (1) year and a period of ninety (90) days on parts and labor. SE/EG, at its option, will repair or refund this product found to be defective during the warranty period. If the product is no longer available, SE/EG may refund your purchase (at a depreciated value), with an original proof of purchase. [. . . ]