User manual SUNBEAM MIXMASTER HAND MIXER

[. . . ] JCS shall not be liable for any incidental or consequential damages caused by the breach of any express, implied or statutory warranty or condition. This warranty is valid for the original retail purchaser from the date of initial retail purchase and is not transferable. JCS dealers, service centers, or retail stores selling JCS products do not have the right to alter, modify or any way change the terms and conditions of this warranty. Doing business as Jarden Consumer Solutions or if in Canada, Sunbeam Corporation (Canada) Limited doing business as Jarden Consumer Solutions (collectively "JCS") warrants that for a period of one year from the date of purchase, this product will be free from defects in material and workmanship. [. . . ] Turn attachment slightly and push in until it clicks into position. (See Figure A) Plug into the appropriate outlet. Turn mixer on and adjust speed setting using the control on the top of the unit. NOTE: The whisk and drink rod may be inserted into either opening on the bottom of the mixer. Whenever scraping of the bowl is required, stop the mixer and scrape sides and bottom of bowl with a rubber spatula as needed. Turn speed control to "OFF" and rest mixer on its heel rest while adding ingredients. Make sure to position beaters over mixing bowl so any drippings will fall back into the mixing bowl. When mixing is complete, set speed control to "1" and raise beaters slowly from batter to clean off clinging food. Make sure to turn unit to "OFF" before raising beaters completely out of mixing bowl. SPEED CONTROL DIAL/ATTACHMENT EJECT BUTTON ­ The hand mixer features a large and conveniently located speed control button that also functions as the beater eject button when in the "OFF" position. The design allows for a smooth push of the thumb to release the beaters. There will be a noticeable "click" when ejecting beaters. BURST OF POWER ® BUTTON (Models 2525, 2526, 2545 & 2546) ­ During especially heavy mixing tasks, press the button to drive through the mixture with ease. Once the button is released, the mixer will return to the original speed setting. When winding the cord, hold the plug with one hand and press the winding button with the other hand. In case cord is not fully rewound, pull out the cord and steer cord evenly on the reel. In case the cord is not pulled out easily, pull cord firmly. Select the amount of cord desired before plugging into an electrical outlet. Do not allow children to use retractable cord feature as the cord may cause injury. DOUGH HOOKS ­ Use these hooks to knead light dough or other heavy batters. NOTE: The dough hook with the collar fits into the left drive hole and the other one goes into the right. (See Figure B) If dough hooks do not click into the drive holes, reverse and try again. [. . . ] This appliance has a polarized plug (one blade is wider than the other). To reduce the risk of electric shock, this plug will fit in a polarized outlet only one way. When building up a recipe that requires the addition of dry ingredients, such as flour, slow the speed down while these ingredients are being added to avoid a snowstorm effect. Once the extra ingredients begin combining, slowly increase to the appropriate speed for the particular mixing task. [. . . ]