User manual SUPPORTPLUS URC22D-8

[. . . ] If it is 1 2008-06-08 USER MANUAL FOR URC22D incorrect, the LED will blink twice and keep being at setup mode (being on). Try if keys on Remote Control work or not. If most keys work improperly, please try other code under the same brand (For example: code 004, 023 . . . . . . [. . . ] Whenever you want to leave search mode, press the device key, and the LED will turn off. In the search mode, besides the [POWER] key, all other key's function can be checked normally. That is to say you can test other keys without leaving search mode. The URC22D-8, The URC22D-8A, The URC22D-8B unit will leave search mode automatically if no key is pressed in 30 seconds. Set Up By Auto Search This search is similar to Manual Search but the remote control transmit the power signal automatically instead of manually pressing power key. Power on the device you want to control. If it is a VCR, it must be inserted with a tape. Press and hold [SET] key, in the meantime, press and hold the Device key (for 2 2008-06-08 USER MANUAL FOR URC22D example: TV1) for more than 3 seconds and then release them, the auto search begins. The remote control enters into Auto Search, LED flashing, and remote control transmits power signal every 2. 0 seconds automatically. See if the device reacts or not, once the device reacts, press any key (except SET key) to stop the auto search. Test if the other keys work good enough. If most keys work not good enough, please go to step B-D using Auto Search again to find the best code. Remark: A. whenever you want to leave Auto Search mode, press any key (except SET key) to quit, and the LED will be off. When remote control searches through all different type of codes (about 5 minutes), LED will have been on for 2 seconds, then the remote control will quit from search process automatically. In case of you do not stop the auto search on time when you find the device reacts, you may use the M anual Search to search back to find the reactive code. Device Lock/Unlock This function will make one device code fixed and can not be changed by code setup by Manual Search or Auto Search: A. Strike the device key that you want to fix such as [TV1], [SAT], [AUX], etc B. Press and hold the [SET] key, then press the [7] key, then release the both pressed keys, the LED will blink once then off, the code of the current device are locked. If you want unlock the current code, press and hold the [SET] key, Then press the [8] key, then release the pressed keys, the LED will blink once and then off, the current code unlocked. Remark: A. The fixed code can be changed by unlock or reset only. [. . . ] If there is no blink, the digit is zero. For example: SET+1 (first digit): LED blinks 1 time SET+2 (second digit): LED blinks 3 times SET+3 (third digit): LED blinks 8 times The indicated code is: 138 Others A. After you have finished set- up, first please press the device key (TV or VCR. . . ) on remote control that you want to use, then operate your remote control normally. B. [. . . ]