User manual SUUNTO BIKE POD

[. . . ] EN CUSTOMER SERVICE CONTACTS Global Help Desk Suunto USA Phone Canada Phone Suunto website +358 2 284 11 60 +1 (800) 543-9124 +1 (800) 776-7770 www. suunto. com COPYRIGHT This publication and its contents are proprietary to Suunto Oy. Suunto, Wristop Computer, Suunto Bike Pod, Replacing Luck and their logos are registered or unregistered trademarks of Suunto Oy. While we have taken great care to ensure that information contained in this documentation is both comprehensive and accurate, no warranty of accuracy is expressed or implied. Its content is subject to change at any time without notice. 1. [. . . ] Fit the quick-release lever to the hub, with the lever to the left (to the right when using disc brakes). Close the lever, taking care to position it horizontally towards the rear (+/­ 45°). Adjust the tension on the adjusting nut so that sufficient force is applied when the locking lever is moved to the "CLOSE" position (consult your retailer). When the locking lever can be moved to the "CLOSE" position too easily, the wheel is not held in place with sufficient force. If this is the case, put the locking lever in the "OPEN" position and tighten the adjusting nut to increase the force. Push the locking lever to the "CLOSE" position. In all cases, make sure that the nut is sufficiently screwed on. The end of the skewer should not be deeper than 2 mm (1/16 inch) inside the nut. +/- 45 6. Attach the holder for your Suunto wristop computer to the handle bar with the flat part facing up. Place the Suunto t-series wristop computer around it. (See the figure under point 5 in section 3. 1. 3. ) 3. 2. 3. INSTALLING THE MAGNET MOUNT Position the magnet mount on a spoke so that it passes in front of one of the marks on the lever. The magnet must be turned towards the Bike POD. · Hub (1) · Magnet (2) · Bike POD (3) 3. 3. ACTIVATION AND DEACTIVATION Your Bike POD is activated automatically when the spoke magnet passes the Bike POD, i. e. It stays active throughout the cycling trip and for half an hour after the Bike POD has stopped receiving readings from the magnet. 3. 4. CONNECTION To use your Bike POD, you must establish a connection between it and your wristop computer. This can be compared to listening to a radio. To be able to receive the radio broadcast signal, you need to switch the radio on. Similarly, for your wristop computer to be able to receive the signal from your Bike POD, the devices must be connected. You need to establish the connection every time you want to use your wristop computer with your Bike POD. Spin the front wheel so that the spoke magnet passes the Bike POD. In your Suunto t6, select Connect in the Speed/Distance menu. In your Suunto t3 or Suunto t4, enter Training mode. [. . . ] You can always download the latest version of the Suunto Training Manager free of charge from www. suunto. com. 5. TECHNICAL SPECIFICATIONS · Weight: · Universal Bike POD: 18g / 0. 6oz (Including battery and magnet) · Road Bike POD: 69g / 2. 4oz (Including skewer, battery and magnet. Adds approximately 10g / 0. 4oz to your normal quick release. ) · Water-resistance: 10 m / 33 ft. · Operating temperature: -20°C to +60°C / -5°F to +140°F · User replaceable battery: 3V CR2032 · Transmission range: up to 10 m / 30 ft. [. . . ]