User manual SUUNTO CORE

[. . . ] en USER GUIDE MODES AND VIEWS TIME · date · seconds · dual time · sunrise and sunset times · stopwatch · countdown timer · empty COMPASS · time · cardinals · bearing tracking ALTI & BARO altimeter barometer depth meter · log recorder · log height difference · log ascent · log descent · altitude difference measurer · temperature · empty · temperature · log recorder · altitude reference · time · empty · log recorder · temperature · time MENU CONTENT SYMBOLS ON THE DISPLAY 1 Welcome . 12 4. 1. 4 Setting sunrise and sunset times . 18 5. 2 Setting profiles and reference values . 19 2 5. 2. 1 Matching profile to activity . [. . . ] When the ALTIMETER profile is activated, the word ALTI is underlined on the display. 22 en When the ALTIMETER profile is activated, you can access the following views with [View]: Log recorder: records the altitude changes into logs Altitude difference measurer: measures the altitude difference from a set point Temperature: measures the current temperature Empty: no supplementary information 5. 5. 1 Using altitude difference measurer The altitude difference measurer shows the difference in altitude between a set point and your current position. This feature is especially useful for mountain climbing, for example when you want to track your progress in terms of altitude climbed. To use the altitude difference measurer: 1. In the ALTI & BARO mode, select the altitude difference measurer view. Start, stop and restart it with [Start Stop]. Keep [+] pressed to reset. 23 Possible real life situation: Measuring your climbing You are about to start climbing a mountain that is 3, 280 feet (1000 m) high. You want to be able to check your progress as you climb, so you activate the altitude difference measurer on your Suunto Core. You start climbing, checking your altitude occasionally to see how far you are from the next check point. You check your altitude, and see that there's still a lot of climbing ahead. Maybe you need to rethink your next check point. 5. 5. 2 Recording logs The log recorder stores all your movements in altitude between the start and stop times. If you are engaged in an activity in which your altitude changes, you can record the altitude changes and view the stored information later. You can also set altitude marks (laps), allowing you to view the duration and ascent/descent height between your previous mark and current mark. Your marks are stored in memory and you can access them later. In the ALTI & BARO mode, select the log recorder view. Start, stop and restart it with [Start Stop]. When you are recording a log, set laps with [+]. Keep [+] pressed to reset (this can only be done when the recorder is stopped). Log height difference: shows the measured altitude difference between a log starting point and a log finishing point with the following icons: In the additional views: is displayed when your altitude is above the starting point. 24 is displayed when your altitude is the same as at the starting point. is displayed when your altitude is below the starting point. is displayed when you view how much you have ascended from the log start. is displayed when you view how much you have descended from the log start. Altitude points are recorded according to the recording interval you have chosen (see Section 7. 3 Choosing recording interval on page 41). [. . . ] NOTE: To reduce the risk of fire or burns, do not crush, puncture or dispose of used batteries in fire or water. Replace the battery with a manufacturer-approved battery only. Recycle or dispose of used batteries properly. Use a coin to open the battery compartment on the back of your device. [. . . ]