User manual SWEEX LW050V2

[. . . ] Englishversion LW050v2/LW050v2UK Sweex Wireless Broadband Router 54 Mbps Introduction First of all, many thanks for purchasing this Sweex Wireless Broadband Router 54 Mbps. The Sweex Wireless Broadband Router 54 Mbps enables you to share a broadband Internet connection and to set up your own wireless network. To ensure this product operates correctly, we advise you to carefully read this manual first. If despite this manual you still experience problems during installation or operation of this product, go to www. sweex. com and look under the heading service & support. [. . . ] The "WAN" section will display your Internet IP address. It can sometimes take up to 1 minute for this IP address to appear. You have now completed the configuration and are ready to surf the Internet. If after 1 minute your IP address continues to show as 0. 0. 0. 0, check your settings again and complete the following steps: 1. Disconnect the network cable between the router and the modem at the "WAN" port. Switch on the router and wait until it is fully started up. Switch on the modem and wait until it is fully started up and until all the correct lights are lit. Reconnect the network cable between the modem and the router via the "WAN" port of the router. Connect the router via 192. 168. 50. 1 and check your Internet connection in the status screen. 1 Englishversion Setting4PPTP 1. Left in the column, click "Network". Under "WAN Connection Type" select "PPTP". This setting is for providers who use a PPTP or KPN Mxstream connection. Under "User Name" enter the user name you received from your provider. Under "Password", enter the corresponding passport. Click "Save" to save the settings. Click "Connect" to make the Internet connection. Next to this button, the message "Connected" will appear and your Internet IP address will be displayed under "Internet IP Address". It can sometimes take up to 1 minute for this to be shown. You have now completed the configuration and are ready to surf the Internet. If after 1 minute the router continues to show as "Disconnected", check your settings again and complete the following steps: 1. Disconnect the network cable between the router and the modem at the "WAN" port. Switch on the router and wait until it is fully started up. [. . . ] Log in twice, using your new user name and password. Upgradingthefirmwareoftherouter(Firmware) In order to provide the router with updates, the so-called `firmware' needs updating. Left in the menu, click "System Tools" and then "Firmware". 2 Englishversion Here the firmware of the router can be upgraded. New firmware can be downloaded from the Sweex website under "Service en support". If the firmware file is zipped, make sure you select and extract the file first on a location in your computer where you can retrieve it easily. [. . . ]