User manual SWISHER POL10544C

[. . . ] swisherinc. com OWNER'S MANUAL STARTING SERIAL #: L204-159001 MODEL NO. POL10544C POLARIS 44" FINISH CUT TRAILMOWER IMPORTANT Read and follow all Safety Precautions and Instructions before operating this equipment. Rev. 05-041 Assembly Operation Service and Adjustment Repair Parts PHONE 660-747-8183 Made In The 1602 CORPORATE DRIVE, WARRENSBURG, MISSOURI 64093 FAX 660-747-8650 Manufacturing quality lawn care equipment since 1945 10020 USA LIMITED WARRANTY The manufacturer's warranty to the original consumer purchaser is: This product is free from defects in materials and workmanship for a period of one (1) year from the date of purchase by the original consumer purchaser. We will repair or replace, at our discretion, parts found to be defective due to materials or workmanship. [. . . ] · Attach tow hitch (4582) to the swivel hitch with hitch pin (H11). Make certain the hitch pin goes completely through each piece and is clipped to prevent accidental separation. (FIGURE FOUR) · Securely attach safety tether (6736) to tow vehicle and to the TrailMower toggle switch located on right side of the engine. The safety tether will stop the TrailMower engine either manually or if the two should become separated. It is very important that the safety tether is securely attached to both the toggle switch and to the tow vehicle. (FIGURE TWO) TRANSPORTING MOWER · Stop TrailMower. · Place TrailMower deck in its highest position. · When transporting unattached from tow vehicle, remove spark plug wire and place it where it cannot contact the spark plug. 6 ENGAGING BLADES (without T-handle option, Standard) The TrailMower will not start if the blade lever is in the "ENGAGED" position. · Engage blades by rotating blade lever into the "ENGAGED" position. · Rotate blade lever in opposite direction to disengage blade. · The dual braking system is applied when the blades become disengaged. It is designed to bring the blades to quick stop (approximately 7 seconds). Each TrailMower brake system has been tested and calibrated. For safety, the consumer should not alter the braking system. ENGAGING BLADES (with T-handle option, for order information see detail) The TrailMower will not start if the T-handle console is in the "ENGAGED" position. · Engage blades by pulling T-handle lever into its horizontal position. · Return lever to its vertical position to disengage blades. · The dual braking system is applied when the blades become disengaged. It is designed to bring the blades to quick stop (approximately 7 seconds). Each TrailMower brake system has been tested and calibrated. For safety, the consumer should not alter the braking system. STARTING THE ENGINE See engine manufacturer's recommendations for the type and amount of oil and fuel used. [. . . ] · See engine manufacturer's recommendations for servicing. Do not store engine indoors or other poorly ventilated area. Keep engine away from gas appliances and water heaters where fumes could contact open flame, pilot lights, or sparks. If engine is to be stored for 30 or more days, prepare unit as follows: · Drain fuel outside into an approved container. [. . . ]