User manual SWISHER ZT2350

[. . . ] swisherinc. com OWNER'S MANUAL MODEL NO. ZT2350 STARTING SERIAL # L505-353001 "Z" SERIES IMPORTANT Read and follow all Safety Precautions and Instructions before operating this equipment. ZERO TURN HYDROSTATIC DRIVE Assembly Operation Service and Adjustment Repair Parts Rev. BOX 67, WARRENSBURG, MISSOURI 64093 PHONE 660-747-8183 FAX 660-747-8650 Made In The Manufacturing quality lawn care equipment since 1945 11847 USA The manufacturer's warranty to the original consumer purchaser is: This product is free from defects in materials and workmanship for a period of two (2) years from the date of purchase by the original consumer purchaser. We will repair or replace, at our discretion, parts found to be defective due to materials or workmanship. [. . . ] FORWARD MOVEMENT: Position steering handles inward to the drive position. To move the mower forward gently push both steering levers forward equal distance from the neutral position. The further you move the levers forward the faster you will travel. CAUTION steering levers have quick response timing. BACKWARD MOVEMENT: To move the mower backwards, gently pull back on the steering levers the same distance from neutral. The further you pull back the faster you will travel. NOTE it is normal for the reverse speed to be less than the forward for easier turning. TURNS: For left turn, move the right lever farther forward then the left. For right turn, move the left lever farther forward than the right. To obtain a tight turning radius, GENTLY reverse one lever and push the other lever forward. CAUTION: Aggressive turns can damage lawns. Do not make turns with the inside wheel stopped. It it better to keep both wheels turning slightly. DECK HEIGHT ADJUSTMENT: To raise the mower deck up and down, simply rotate the lever located in front of the seat above the floor plate. The deck is adjustable from 1 ½" to 3 ½". For best performance, tall grass should be mowed once in the highest position and once again at desired cut height. Never cut more than1/3 the height in one cutting. ENGAGING BLADES: Operator must be seated for operation of blades. With engine to full throttle position, pull UP on PTO switch located between the throttle and the key switch. To disengage blades, push DOWN on PTO switch. STOPPING ENGINE: Place both levers in the outward neutral locked position. Place throttle lever to lowest setting and let idle for 30 seconds. [. . . ] Swisher Mower recommends that you retain all receipts covering maintenance on your Power Equipment, but Swisher Mower cannot deny warranty solely for the lack of receipts. As the Power Equipment owner, you should be aware that Swisher Mower, may deny you warranty coverage if your Power Equipment, or a covered part has failed due to abuse, neglect, or improper maintenance, unapproved modifications, or the use of parts not made or approved by the equipment manufacturer. You are responsible for presenting your Power Equipment to an authorized Swisher Service center as soon as the problem exists. Warranty repairs should be completed in a reasonable amount of time, not to exceed 30 days. [. . . ]