User manual SYLVANIA 3919LC

[. . . ] QUICKSTEP bi-level step dim ballasts are specifically designed to meet California's Energy Efficiency Standards (Title 24) for multi-level lighting controls, (Section 131). The combined lamp and ballast system offers a high efficiency system for T8 luminaires along with high performance features that are standard on SYLVANIA HIGH EFFICIENCY Series ballasts. [. . . ] The combined lamp and ballast system offers a high efficiency system for T8 luminaires along with high performance features that are standard on SYLVANIA HIGH EFFICIENCY Series ballasts. QUICKTRONIC QHE PROStart delivers an optimized programmed rapid start technology which extends T8 lamp life and allows over 100, 000 switching cycles for occupancy sensor and building control systems applications. The QUICKTRONIC PROStart QUICKSTEP ballasts also meets the requirements for the NEMA Premium Ballast, (NPB) program. The NPB program promotes the use of high efficiency T8 electronic ballasts by meeting or exceeding the Ballast Efficiency Factors, (BEF) established by the CEE, (Consortium for Energy Efficiency). For additional information on this program go to: www. cee1. org or www. nema. org Key System Features · QUICKSTEP Stepped Switching, bi-level dimming (0. 87 BF to 0. 34BF) · High Efficiency Systems ­ over 90% efficient · NEMA Premium Ballast compliant · California Title 24 compliant · PROStart Programmed Rapid Start · Extends lamp life · Universal input voltage (120-277V) System Information SYLVANIA QUICKTRONIC PROStart QUICKSTEP High Efficiency (QHES) ballasts operate from 120V through 277V, eliminating "wrong voltage" wiring errors and reducing the number of models in inventory by 50%. QUICKSTEP QHES PROStart system has two AC line inputs in addition to the neutral wire. Pallet Pack contains 840 pieces, (add "-PAL" to Description). 1: Ballast Efficiency Factor (BEF) shown = (Ballast Factor x 100) divided by Input Wattage (Note: calculation based on lowest input wattage). Installation Notes · Install in accordance with National & Local Electric Code · Ground Ballast Case · The AC line inputs must be connected to the same phase of the line voltage · DO NOT CONNECT two separate phases of line voltage to the input of QUICKSTEP ballasts, the ballast will be damaged and not covered by warranty Specifications Data based on F32T8 Starting Method: Programmed Rapid Start Ballast Factor: 0. 87/0. 34 Circuit Type: Series Lamp Frequency: >40 kHz Lamp CCF: Less than 1. 7 Starting Temp:2 0°F/-18°C for OCTRON T8 lamps; 32°F/0°C in dimmed mode Input Frequency: 50/60 Hz THD: <10% (full power) <20% (@50% power) Power Factor: >97% (full power) Voltage Range: ±10% UL Listed Class P, Type 1 Outdoor CSA Certified 70°C Max. warranty) FCC 47CFR Part 18 Non-Consumer Class A Sound Rating ANSI C62. 41 Cat A. Transient Protection Remote Mounting (Max. wire length from ballast case to lampholder): up to 7 feet (keep blue wires short, ie. lamp(s) attached to the blue leads to remain in the fixture that houses the ballast). 2 Operation below 50°F/10°C may affect light output or lamp operation ­ see "Low Temp. [. . . ] wire length from ballast case to lampholder): up to 7 feet (keep blue wires short, ie. lamp(s) attached to the blue leads to remain in the fixture that houses the ballast). 2 Operation below 50°F/10°C may affect light output or lamp operation ­ see "Low Temp. [. . . ]