User manual SYNQ AUDIO RESEARCH LS-WH-DMX CONTROL V1.0

[. . . ] The exclamation point within the equilateral triangle is intended to alert the user to the presence of important operation and maintenance (servicing) instructions in the literature accompanying this appliance. This symbol means: indoor use only This symbol means: Read instructions This symbol means: Safety Class II appliance To prevent fire or shock hazard, do not expose this appliance to rain or moisture. To avoid condensation to be formed inside, allow the unit to adapt to the surrounding temperatures when bringing it into a warm room after transport. Condense sometimes prevents the unit from working at full performance or may even cause damages. [. . . ] When installed in a booth or flight case, please make sure to have good ventilation to improve heat evacuation of the unit. To avoid condensation to be formed inside, allow the unit to adapt to the surrounding temperatures when bringing it into a warm room after transport. Condense sometimes prevents the unit from working at full performance. CLEANING THE APPLIANCE: Clean by wiping with a polished cloth slightly dipped with water. Do not use volatile liquids such as benzene or thinner which will damage the unit. Frequency band , while turning to the left cuts the band. The following table shows the EQ type, frequency, and maximum cut/boost for each of the three bands. For more information on connections, please refer to the next chapter. Be sure to turn off the mixer before you make changes to the different connections. In this manual we talk about "line inputs". This is a global name for inputs with a level between 750mV and 2V. This control adjusts the channel's MIC input sensitivity between -50dB and -6dB and the line input sensitivity between -30dB and +14dB. To turn the HPF on, press the switch In ( frequencies below 75Hz 4. EFX RTN VOLUME KNOB Adjust the level of the signal sent from the internal digital effect to the MAIN bus. AUX STEREO RETURN CONTROL Adjusts the level of the signal coming from the AUX RETURN connectors (L and R), routed to the MAIN L/R bus. TAPE IN CONTROL This knob controls the level of the playback signal that is coming from the TAPE IN RCA connectors, and that will be routed to the MAIN L/R output. LEVEL METER This LED display shows the level of the MAIN L/R output signal. This indicator lights when power switch of the mixer is turned on. CHANNEL INPUTS BALANCED MIC XLR Connectors These are balanced XLR-type input jacks (1: Sleeve, 2: Hot, 3:Cold) BALANCED LINE IN JACK Connectors A standard 1/4" TRS phone jack is used for balanced or unbalanced line level signals, like used with most electronic keyboards, synthesizers, tape decks and the line outputs from other mixers. CHANNEL INSERT I/O JACK These are input/output jacks located between the head-amplifier and the high pass filter. These jacks can be used to independently connect these channels to devices such as graphic equalizers, compressors, and noise filters. These are 1/4" TRS (tip, ring, sleeve) phone jacks that support bi-directional operation. [. . . ] When the mixer detects no connector in the R input, it will spread the signal of the L MONO Jack input over both L and R channels. TAPE IN RCA connectors Use these RCA connectors when you want to connect a CD, DAT or other external sound source directly to the mixer for monitoring. You can adjust the signal level using the TAPE/USB control in the MAIN CONTROL SECTION. REC OUT RCA connectors The REC OUT connectors send the pre-fader signal from the master bus. [. . . ]