User manual SYNQ AUDIO RESEARCH SUPER SOLAR RGBW V1.0

[. . . ] CAUTION: To reduce the risk of electric shock, do not remove the top cover. This product meets the requirements of the current European and national guidelines. 2 user modes: Dimmer mode: you can control 16 dimmer channels gradually (extendable up to 64channels) Scene mode: you can create 16 scenes, each containing 16channels (extendable to 64scenes, each containing 64channels) MIDI functionality via USB (16ch): MIDI OUT: all channel faders + flash buttons can also send out MIDI-commands so you can control different MIDI applications (ex. arkaos , Resolume , DMX-Creator , Daslight , . [. . . ] Remark: in both working modes MIDI data (000-127) is sent through the USB-output (10) 2. FLASH BUTTONS: can be used for different purposes, depending on the working mode: Manual mode: used as channel FLASH button (max. Output as long as the button is pressed) Scene mode: CHANNEL fader closed switch the programmed scene on/off. CHANNEL fader not closed used as scene FLASH button. (set scene at 100%) Remark: in both working modes MIDI data (note on/off) is sent through the USB-output (10) 3. STATUS LED: information depends on the working mode: Manual mode: lights up progressively, depending on the fader position. Scene mode: dark while no scene is programmed (empty). Lit while a scene is programmed but not active. Blinking while a scene is programmed and active (shown on the output) 4. SCENE/MANUAL BUTTON: used to toggle between manual mode and scene mode: Manual mode: each of the 16 CHANNEL faders can be used to manually set the output level. Scene mode: each of the 16 CHANNEL faders can contain a scene, scenes can be mixed manually. See chapter "HOW TO USE" to learn more about using MIDI on the Scenemaster. To obtain more channels, just link several controllers together (see below). LINKING SEVERAL UNITS TOGETHER If 16 channels and/or scenes is not enough for your application, don't worry: you can link several units together. The drawing shows the maximum of 4 units but you can also use the following combinations: 2 units: 1master + 1slave = 32 scenes + channels. Linking the units is very easy: just use standard RJ-45 cat5 patch cables as used in Ethernet computer networks. (we also supply these cables: 0, 5m = order code 5151 or 1, 5m = order code 5152). Switch the controllers on: the controllers will link automatically, on the left of each display you will see the "unit ID"-number. Important remark: the controls numbered 4 to 9 on the front panel drawing can ONLY be used on the master unit, on the slaves these controls are NOT used!USE IN MANUAL MODE The simplest way to use the Scenemaster: Press the SCENE/MANUAL button (4) to switch the controller to manual mode. Use the CHANNEL faders (1) and FLASH buttons (2) to create the desired output. remark: use the DISPLAY button (6) to show the desired DMX-values on the display (0-512 or 0-100%). [. . . ] EDIT SCENES Any programmed scene can still be edited using the following steps: A. Scenes can only be edited while the unit is set in "program mode". So first enter "program mode" by pressing the SCENE/MANUAL (4) and PROGRAM (8) buttons together red "program LED" is lit. Press the FLASH button (2) of the scene that needs to be edited: the corresponding status led (3) starts flashing while the scene is shown on the DMX-output, ready to be adapted. [. . . ]