User manual SYNQ AUDIO RESEARCH TMC 200

[. . . ] `t Hofveld 2C ~ B1702 Groot-Bijgaarden ~ Belgium Reproduction or publication of the content in any manner, without express permission of the publisher, is prohibited. Dispose of the unit and used batteries in an environment friendly manner according to your country regulations. Thank you for buying this JB Systems product. To take full advantage of all possibilities, please read these operating instructions very carefully. [. . . ] press CUE(7) to return to the "CUE POINT". If the track is playing, the jog wheel temporarily bends the pitch of the music up to +/-100% by rotating the wheel clockwise to speed it up or counterclockwise to slow it down. In scratch mode (SCRATCH button (28) activated) the jog wheel is used to manipulate playback of the music in real time. As a result you can scratch the music on your CD the way you do this with a normal analog vinyl record. To match the vinyl feel as close as possible and largely improve scratch performance, the the jog-wheel uses a patented touch-sensitive technology!You can manipulate the DSP-effects while they are used in manual mode, see EFFECT buttons (14). This option gives you the possibility to scratch any track on the CD in real time. You can use the scratch function in both play and pause mode: In play mode: The music plays normally until you touch the big jog wheel(27). while manipulating the jog wheel(27) , the scratch effect is audible. Once the jog wheel is stopped, the music continues playing from the point where you stopped turning it. In pause mode: the music is paused for as long as the jog wheel(27) isn't moved. when you start manipulating the jog wheel(27) , the scratch effect is audible. Once the jog wheel is stopped, the music stops playing and waits in pause mode. NOTE: during scratch mode you can switch between play and pause mode by simply pressing the PLAY/PAUSE button(8) Use the supplied cinch/cinch cable to connect this output to a CD/line input of your mixing unit. Digital out socket: Use this connector to connect the digital signal (S/PDIF format) to the input of a digital amplifier or digital recorder (ex. RELAY Socket: you can use this connector in two ways: you can use it with the fader start option on certain mixers or you can connect two TMC200 players together to obtain the relay play function. relay play: Use the supplied mono mini jack/jack cable to connect the RELAY sockets of two TMC200 players together. Look further in this manual to learn how to perform the relay play function. Fader start: If you are using a mixer with fader start function, use the supplied mono mini jack/jack cable to connect the player with the fader start of the mixer. Please note that this socket must never be connected with any voltage. Attention: This remote control is only compatible with certain (Synq® or Pioneer® compatible) mixers. Mixers with remote starts functioning with a signal switched to ground will not work. [. . . ] Cue points stored: When you select a track where cue points or loops are stored in permanent memory, the TMC200 shows "Load Cues?" and wants to know if you want to load the cue points. This is what you can do: You press the YES button: Press yes (pitch bend + button) to load the pre-stored cue points and loops. The display shows RECALL while the Hot cue buttons are filled up. [. . . ]