User manual T-FAL NEFTIS

[. . . ] ⷠDo not use the appliance if the power cord or the plug are damaged. To avoid danger, always have the power cord replaced by an approved service centre. ⷠNever place the appliance, po wer cord or plug in water or any other liquid. ⷠDo not allow the po wer cord to hang down within reach of children. [. . . ] ⷠThis coffee maker is fitted with a drip-stop device, allowing you to serve coffee before the water has finished percolating. Replace the jug quickly to avoid any overflow. ⷠYou can reheat coffee by placing the jug (depending on model) in the microwave. on models equipped with a permanent filter: O · Place ground coffee directly into the permanent filter . Dispose of the coffee grounds after use and rinse the filter under the tap. Some models are equipped with a jug with a Thermocontrol indicator: · This device indicates whether the coffee inside the jug is at a suitable temperature for drinking. If the indicator is black, the coffee in the jug is too cold. Some models are supplied with an insulated flask: · To keep your coffee warm for longer, rinse the insulated flask with hot water before use. ⷠAlways screw down the lid fully (by turning it clockwise) when making coffee and keeping it warm. S PROGRAMMING YOUR COFFEE MAKER (depending on model) When you switch the coffee maker on, the time display flashes and reads ; the cup and clock symbols are on steady. Set the hours by pressing the button repeatedly, or hold it down to cycle continuously through the hours . Set the minutes by pressing the button repeatedly, or hold it down to cycle continuously through the minutes . The clock symbol disappears (if you do not confirm by pressing this button within 30 seconds, the appliance cancels the changes and reverts to the existing time). Operating the coffee maker manually cancels any automatic start that may have been programmed. Programming the coffee maker to start automatically (not possible until the clock has been set): · press the button once . The cup and the hours display starts flashing. Set the hours by pressing the button repeatedly, or hold it down to cycle continuously through the hours . Set the minutes by pressing the button repeatedly, or hold it down to cycle continuously through the minutes . The cup symbol stops flashing to indicate that an automatic start has been set (if you do not confirm by pressing the button within 30 seconds, the appliance cancels the changes and reverts to the existing time). You can pause and resume the coffee-making cycle at any time by pressing the start/stop button. [. . . ] ⷠLeave the descaling product to work for one hour. ⷠRestart the coffee maker to complete the cycle . ⷠRinse the coffee maker by running 2 or 3 cycles with 1 litre of water. The warranty does not cover coffee makers that malfunction or cease to operate because they have not been regularly descaled. [. . . ]