User manual T-FAL PRINCIPIO

[. . . ] - Unplug the appliance as soon as you have finished using it and when you clean it. - Do not use the appliance if it is not working properly or if it has been damaged. Any intervention apart from cleaning and normal maintenance by the customer must be carried out by an approved service centre (see list in the service booklet). - Do not place the appliance, the power cord or the plug in water or in any other liquid. [. . . ] 2 Plug the coffee maker into an electrical socket, which meets the voltage indicated on the appliance. 3 Fill the jug with fresh, cold tap water. Markings on the tank indicate the level of water required for brewing the desired number of cups. 4 Place a coffee filter paper in the filter holder. Measure one level tablespoon of regular grind coffee for each cup of coffee desired. For stronger or milder coffee, adjust the amount of coffee to suit your taste. 5 Return the filter holder to its base and close the lid. The on light will indicate the unit is in operation. 8 If your wish to serve a cup of coffee before the end of the brewing cycle simply remove the jug from the warming plate. Return the jug to its position on the warming plate within 45 seconds and brewing will resume. 9 Upon completion of the brewing cycle, wait approx one minute before using to allow any last traces of water remaining in the water tank to filter through. The jug lid should be kept in place to facilitate safe serving and help keep the coffee at a proper serving temperature. 10 To keep the coffee hot, return the jug to the warming plate after serving. the warming plate will automatically maintain the ideal serving temperature providing the coffee maker is switched on. 11 Switch the control button to off when the jug is empty or when the unit is not in use. 12 To brew another jug of coffee, turn the unit off and wait 10 minutes to allow the heating element to cool. Important : if the unit is not allowed to cool sufficiently before repeated use, water placed in the water tank may become overheated and a spray of steam could be released from the opening, creating a risk of burns. S BREWING A SECOND POT OF COFFEE As mentioned above, it is recommended that the coffee maker should be switched off for 10 minutes between cycles in order to allow the unit to cool. While the unit is in the off position, dispose of used coffee and rinse the jug and filter holder in water. Place a fresh filter paper in the holder then repeat brewing procedure. Once coffee has been opened, keep it tightly sealed in the refrigerator to maintain freshness. 2 For optimum coffee, buy whole beans and grind them finely just before brewing. [. . . ] When cooled, pour liquid back into the water tank. Repeat procedure, allowing all the cleaning solution to empty into the jug. After dripping has stopped, discard contents of the jug. 6 After allowing the coffee maker to cool for 10 minutes, rinse it out by filling the jug full of cold water. [. . . ]