User manual T-FAL ULTRAGLIDE EASYCORD FV4269

[. . . ] Read all instructions before using the iron. When using your iron, basic safety precautions should always be followed, including the following: 11. 1 To protect against a risk of electric shock, do not immerse the iron or the base of the iron in water or other liquids. 1 Never yank cord to disconnect from outlet ; instead, grasp plug and pull to disconnect. [. . . ] Your iron heats up quickly, therefore, begin ironing with fabrics that are ironed at lower temperatures first, then go on to those requiring a higher temperature. - It is normal for the temperature indicator light to turn on and off during ironing. - In order to avoid water leaking from the soleplate onto your garment: · Should you need to turn down the temperature, wait until the temperature light comes back on before beginning to iron again. - When ironing fabrics with mixed fabrics , set the iron temperature for the most delicate fabric. - For delicate fabrics, we recommend testing the fabric first on an inconspicious place for example, inside the hem. - If you want to iron without steam, set the steam control level to . In order to achieve the maximum amount of steam, it is recommended that you wait a few seconds after you push the burst of steam button again. 9) will release a mist of water onto your fabrics. Every fifth time you press the button, return the iron to the horizontal position. When using the vertical steam function, always iron with the garment on a hanger, never while wearing it. Hold the iron a few inches from the fabric to avoid burning delicate fabrics. The iron is equipped with an electronic system that will automatically cut the power source to your iron if it is left vertically on its heel for more than 8 minutes, on its soleplate for more than 30 seconds or on its side for more than 30 seconds. 11) will flash when the iron is in the shut off mode. ⷠTo restart the iron, gently shake the iron until the warning light stops flashing. When the auto-off warning light is on, it is normal for the temperature light to remain off. When using the iron for the first time, allow 2 minutes for steam to be produced. If the soleplate temperature is too low, the iron will not produce steam because of the anti-drip technology which prevents droplets of water leaking from the soleplate. Wait until the soleplate cools down and empty the water tank. (A little water may remain in the reservoir). ⷠTo wind the cord around the heel of the iron, slide the Easycord system into the knotch in the heel (fig. [. . . ] vacuum the holes of the soleplate from time to time. Make sure that your fabric is rinsed sufficiently so as to remove any deposits of soap or chemical products on new clothes. Clean the soleplate with a damp sponge and lower the temperature. Always spray starch onto the reverse side of the fabric to be ironed. [. . . ]