User manual TALLYGENICOM 6300

[. . . ] 6300 Series Operator Manual Serial - Parallel - LAN - Twinax - Coax - IPDS Operator Manual 1 This Manual is published by TallyGenicom for use with the computer printer described herein. Translations, reprinting or copying by any means of this manual, complete or in part, in any different form requires our explicit approval. TallyGenicom reserves the right to revise this manual without notice, for any reason. This includes, but is not limited to, utilization of advances in the state-of-the-art and changes in the equipment or configuration thereof. [. . . ] If on Auto (the default), the selection will be either Light or Heavy depending on the Print Gap setting. On the Auto setting Paper Weight uses the print gap to sense what is needed. However, in some cases you may want to set it manually. For example, very dense (yet thin) paper may need to be assigned a heavy paper weight to ensure good print quality. Fast Slew Slew refers to the high speed paper motion that occurs whenever the printer moves paper more than one line. If your forms are not too thin or fragile such that output stacking is a problem, you can decrease the printer's slew speed by setting this parameter to Disabled. Double Strike When this parameter is set to Enabled, the printer strikes each dot twice. Use this to get better print quality when you are printing on an exceptionally thick form. Enabling Double Strike decreases the printer throughput by approximately 50%. RibbonMonitor This parameter enables the Ribbon Monitor feature. The options are Enabled and Disabled (default). This feature helps the printer operator determine when to replace ribbons for optimum and consistent print quality. It works by counting the estimated number of characters printed as jobs are printed. Since ribbons are rated for an estimated number of characters, when the character count threshold is reached for the current ribbon the operator is notified via the panel that the ribbon needs to be replaced. Ribbon Monitor can be disabled at any time. However, the "characters printed count" is reset to zero whenever Ribbon Monitor is enabled, so enabling the feature should only be done with a fresh ribbon. If the Ribbon Monitor Fault occurs, and is cleared without the ribbon life threshold being increased or the ribbon count reset to zero, the "Replace Ribbon" message will reappear approximately every one million characters until one of these operations is performed. This message will also appear upon powerup if the ribbon count is above the threshold at that time. 3­54 Operator Manual Operator Menu Forms RibnMon Thresh This parameter sets the ribbon life threshold of the Ribbon Monitor feature. The default option is 40, assuming that a 40 million character ribbon is being used. This option should be changed to 60 or 250 if a 60 million or 250 million character ribbon is used. The setting can be further refined based on the application being printed. [. . . ] This produces consistent print speed even when changing from one CPI to another. Enhanced Mode provides higher resolution and a greater range of CPIs than CDF Mode. Because Enhanced Mode uses a variety of dot densities you should expect a change in print speed of text when switching from one CPI to another. Appendix C: Specifications C­103 Fonts, Languages, and Characters Gothic and Courier These two type styles provide Near Letter Quality (NLQ) printing. They print at higher dot densities and use denser character matrixes for greater readability. [. . . ]