User manual TANDBERG SUPERLOADER DLT QUICK START GUIDE

[. . . ] Reach in through the openings in the foam packaging and grip the autoloader securely. In a coordinated motion with the other unpacker, lift the autoloader out of the box and place it on a flat, stable surface. e While one unpacker steadies one side of the autoloader, the other unpacker should grip the front of the autoloader with one hand and remove the foam packaging from the other side of the unit. Caution Do not rest the autoloader on the unpacked side. [. . . ] Slide the autoloader in place so that the front ears of the autoloader align with the front clip nuts. Then loosely install the four screws that connect the two support brackets to the two front rails. e Loosely install the four screws that connect the support brackets (two screws per support bracket) to the autoloader brackets. Autoloader bracket Front rail f Verify that the autoloader is level. g Tighten the four screws that attach the two front ears to the front rails. Support bracket h Tighten the four screws that connect the two support brackets to the two autoloader brackets. i Tighten the four screws that connect the two support brackets to the two rear rails. 13 Front ear 12 5 Sections 5-9 explain how to set up the autoloader. Make the SCSI connection When installing cables, be careful not to damage the SCSI pins on the connectors. Damaged pins will cause the connection to fail. !Caution a If the host computer is connected to a network, check with the system administrator before turning off power. b Properly power off all peripheral devices connected to the host computer. d Install the supplied 68-pin SCSI cable to the double-stacked SCSI connector that is on the back of the autoloader/DCA and tighten the screws. You can install the SCSI cable in either port. Note: Notice that the connector on the end of the cable is offset. Make sure that you install it with the correct orientation so that you can fit a terminator or another cable in the other port. 14 Double-stacked SCSI connector e If the autoloader will be the last device on the SCSI bus, install the supplied SCSI terminator to the remaining port that is on the autoloader/DCA and then tighten the screws. f Attach the other end of the SCSI cable to the SCSI host adapter card. g Power back on any peripheral devices that you powered off in Step b. Note: Do not power on the host computer at this time. You must configure the autoloader for SCSI and Ethernet prior to powering on the host. 15 6 Connect the power cord Note: The first time you power on the autoloader, do not power on the host. 7 Power on the autoloader When you first power on the autoloader, it automatically runs a Power On Self Test (POST). During the POST, the left (green) LED flashes. After the POST, the left (green) and right (amber) LED flash alternately. · The autoloader performs a calibration and magazine element status. A + appears in the upper right corner of the LCD while calibration is in progress. When the power-on sequence completes and the autoloader is ready, the LCD displays a list of the autoloader options that are present and the Ready LED is steady green. [. . . ] a On the LCD, press Enter and then scroll to Commands. b Scroll to Eject and press Enter. 20 21 Use magazines and magazine blanks, continued Install a magazine For detailed instructions, see the User Manual. a Grasp the magazine by the handle with one hand and support it underneath with the other hand. b Push the magazine in until it clicks and locks into place. [. . . ]