User manual TASCAM 2488 MIDI CONTROL V0.2

[. . . ] 2488 Digital PortastudioTM MIDI Parameter Mapping v0. 2 - April 15, 2004 pkillianey@tascam. com THIS DOCUMENT IS FOR EXPERIENCED MIDI USERS ONLY. This document is written under the presumption that the reader has created a MIDI controller maps in the past, or has the equivalent understanding of MIDI controllers. [. . . ] This "banking" concept is used not only with mixer channels, but also with varoious effect processors, and other functions. (The various bank switches do not affect each other though - mixer banks and effect banks are independent. ) ---------:---------------:---------------:---------------:---------------: MIXER CH : : 1 1 1 1 1 1 1:1 1 1 2 2 2 2 2: : :1 2 3 4 5 6 7 8:9 0 1 2 3 4 5 6:7 8 9 0 1 2 3 4:A B C D E F G H: ---------:---------------:---------------:---------------:---------------: MIDI CH :1 2 3 4 5 6 7 8:1 2 3 4 5 6 7 8:1 2 3 4 5 6 7 8:1 2 3 4 5 6 7 8: ---------:---------------:---------------:---------------:---------------: BANK : 0 : 1 : 2 : 3 : ---------:---------------:---------------:---------------:---------------: The same volume control message (parameter 7) on channel 1 can affect channel 1, 9, 17, or INPUT A. The destination depends on which bank was last activated. (The bank commands does not need to be sent each time. ) Just to make sure the concept is clear, a chart is given below to offer an example of how this works. You'll notice that MIDI channel 15, controller 0 is the controller used to change between the banks of channels for MIDI control. :-------:------:------:------:-------------------------------------------: : SEND : MIDI : CNTR : VAL : RECOGNIZED FUNCTION : : ORDER : CH :# : : : :-------:------:------:------:-------------------------------------------: : 1 : 15 : 00 : 0 : Select Mixer Bank 0 - Channels 1-8 : : 2: 1 : 10 : 127 : Set PAN on CH1 to hard right : : 3 : 15 : 00 : 0 : Select Mixer Bank 1 - Channels 9-16 : : 4: 1 : 10 : 127 : Set PAN on CH9 to hard right : : 5: 4 : 10 : 64 : Set PAN on CH12 to center : : 6 : 15 : 00 : 0 : Select Mixer Bank 0 - Channels 1-8 : : 7: 8 : 07 : 100 : Set VOLUME on CH8 to nominal (0dB) level : :-------:------:------:------:-------------------------------------------: Mixer Channel Controls Mixer channels 1-24 and inputs A-H all offer individual control, using the bank switching method explained previously. The parameters are listed in the chart on the next page. Some key notes on it are below. Tone Generator - Does Not Bank You may notice that the Tone Generator mixer channel also offers the same functions, including the 3-band EQ, effect sends, volume, etc. The audio channel for the tone generator will receive MIDI control messages on channel 13 at any time, independent of bank switching for normal channels. Keep in mind that this only affects the mixer channel that is fed by the Tone Generator - TG. This is not affecting the individual channels inside the Generator. The 2488 does not allow you to have external control over every internal Tone Generator function and the 2488 mixer controls at the same time. On page 2 of this document, mention is given to set MIDI IN MODE to REMOTE, which routes MIDI control messages to the mixer, instead of the General MIDI chip. [. . . ] In the chart, parameters that will map to the Stereo Bus functions are labeled ST. The functions that map as Aux Send masters are labeled MST. :-------------:------:-------:---------------------------:-------------: : PARAMETER : CONT : RANGE : DESCRIPTION : APPLIES TO : : NAME :# : : : TG :ST/MST: :-------------:------:-------:---------------------------:------:------: : CH BANK : 00 : 0- 3 : CHANNEL 15 only; 0=1-8, : : : : : : : 1=9-16, 2=17-24, 3=A-H : : : :-------------:------:-------:---------------------------:------:------: : FADER LEVEL : 07 : 0-127 : 0=-oo, 100=0dB, 127=+6dB : X : ST : : PAN : 10 : 1-127 : 1=L63, 64=C, 127=R63 :X : : : PAD/GAIN : 11 : 0- 8 : :X : : : PHASE INV : 84 : 0- 1 : 0=NORMAL, 1=INVERT :X : : :-------------:------:-------:---------------------------:------:------: : LOW FREQ : 16 : 0- 31 : :X : ST : : LOW GAIN : 17 : 0- 24 : 0=-12dB, 12=0dB, 24=+12dB : X : ST : : MID FREQ : 18 : 0- 63 : :X : ST : : MID GAIN : 19 : 0- 24 : 0=-12dB, 12=0dB, 24=+12dB : X : ST : : MID Q : 20 : 0- 6 : :X : ST : : HI FREQ : 21 : 32-63 : :X : ST : : HI GAIN : 22 : 0- 24 : 0=-12dB, 12=0dB, 24=+12dB : X : ST : : EQ IN/OUT : 80 : 0- 1 : 0=OUT, 1=IN :X : ST : :-------------:------:-------:---------------------------:------:------: : LOOP FX LVL : 23 : 0-127 : :X : MST : : EFF1 LEVEL : 24 : 0-127 : :X : MST : : EFF2 LEVEL : 25 : 0-127 : :X : MST : : LOOP FX POS : 81 : 0- 2 : 0=OFF, 1=PRE, 2=POST :X : : : EFF1 POS : 82 : 0- 2 : 0=OFF, 1=PRE, 2=POST :X : : : EFF2 POS : 83 : 0- 2 : 0=OFF, 1=PRE, 2=POST :X : : :-------------:------:-------:---------------------------:------:------: TG - TONE GENERATOR AUDIO CHANNEL RECEIVES ON MIDI CH 13 ST - STEREO BUS RECEIVES ON MIDI CHANNEL 16 MST - AUX MASTER CONTROL RECEIVES ON MIDI CHANNEL 16 [. . . ]