User manual TASCAM CD-A700

[. . . ] REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. ESPAÑOL OWNER'S MANUAL / MANUEL DU PROPRIETAIRE BEDIENUNGSANLEITUNG / MANUALE DI ISTRUZIONI MANUAL DEL USUARIO / GEBRUIKSAANWIJZING ITALIANO DEUTSCH FRANÇAIS ENGLISH IMPORTANT SAFETY INSTRUCTIONS CAUTION: O Read all of these Instructions. O Save these Instructions for later use. O Follow all Warnings and Instructions marked on the audio equipment. 1) Read Instructions -- All the safety and operating instructions should be read before the product is operated. [. . . ] The SHUFFLE indicator lights in the display. Repeat Function The repeat function allows repeat playback of any single tune, the entire disc, or any desired portion on the disc designated by two (start and end) points. O The repeat functions can be released by pressing the repeat button again. To repeat a designated section (A-B Repeat mode) 1. Start playback from any point before the section to be designated. Designate the point at which repeat playback should start (point A) by pressing the A-B button. The REPEAT and A - indicators light and the B indicator blinks to show that point A has been entered. 2. Tracks will be randomly selected and played back. To repeat one tune (Single Repeat mode) 1. The REPEAT and SINGLE indicators light. O Press the Æ button with the random play function engaged to select a tune at random. Press the Ú button to replay the currently played tune from its beginning. O A tune cannot be replayed after it has been played in this mode. O To release the random play function while it is engaged, press the SHUFFLE button again. Tunes will play back in their normal designated order, starting from the currently played tune. 3. 4 Total remaining time display (TOTAL REMAIN) Displayed when the TIME button is pressed twice. The time displayed is the total remaining playback time from the position being played, to the end of the disc; the counter counts down to "00:00" during playback. Intro Check Function The intro check function allows only the beginning of each track to be played for 10 seconds. The INTRO and indicators will be indicated. Press the INTRO CHECK button again to clear the intro check function. O The intro check function also works together with SHUFFLE, PROGRAM and REPEAT ALL functions. O Displayed after the TIME button is pressed three times. The time displayed is the elapsed playback time 2. O In Normal Playback mode, if a tune with a number higher than 32 is being played, the remaining time will not be displayed in the time counter even when the TIME button is pressed. Instead, "nn:nn" will be indicated on the time indicator. _ 10 _ Cassette Deck Operation Playback 1. Set the REV MODE switch to the required tape travel mode. INPUT COUNTER RESET STOP RECORD 3. Load a pre-recorded cassette with its open edge facing down and side A facing toward you. Press the " or button to start playback. [. . . ] If this product is not provided with a mains plug, or one has to be fitted, then follow the instructions given below: IMPORTANT. DO NOT make any connection to the larger terminal which is marked with the letter E or by the safety earth symbol ç or coloured GREEN or GREEN-and-YELLOW. The wires in the mains lead on this product are coloured in accordance with the following code: BLUE: NEUTRAL BROWN: LIVE As these colours may not correspond with the coloured markings identifying the terminals in your plug proceed as follows: The wire which is coloured BLUE must be connected to the terminal which is marked with the letter N or coloured BLACK. The wire which is coloured BROWN must be connected to the terminal which is marked with the letter L or coloured RED. [. . . ]