User manual TASCAM DA-60MKII QUICKTIPS

[. . . ] [. . . ] If using WORD Clock, sampling frequencies must also match. CHECK DA-60MKII SYSTEM VERSION 1) Displayed at Power On COPY ID PROVISIONS 1) Hold SHIFT and press MENU v or w until you arrive at screen display "4 coPy" 2) Press DATA and rotate the DATA DIAL to select one of the three available options, then press SET to confirm the operation Note: "id-6 00" - any number of digital copies can be made "id-6 10" - no digital copies can be made "id-6 11" - only one digital copy is possible, copies may not be duplicated CROSSFADE TIME 1) Hold SHIFT and press MENU v or w until you arrive at screen display "9 FAdE XX" (XX = current value) 2) Press DATA - the current time value will blink 3) Rotate the DATA DIAL until the desired value is displayed 4) Press SET to complete this procedure 1) Press MENU v or w and select "s EXT TC" As tape plays, press either MEMO 1 or MEMO 2 2) To autolocate to either memo point, press LOC 1 or LOC 2 1) 1) EXTERNAL TIME CODE DISPLAY MEMO POINT CAPTURE AND AUTOLOCATE MEMO POINT TRIM Press MENU v or w and select either "s MEMO1" or "s MEMO 2" (this is visible in the upper right of the display) 2) Press DATA- the "hour" digits of the memo address screen will blink and successive presses of DATA enable you to cycle from "minutes" to "seconds" to "frames" and back to "hour" 3) Using the DATA DIAL and DATA key, trim the memo address to your liking 4) Press SET to confirm the edit 2 MEMORY START PLAY 1) 2) 3) 4) Unless you are starting from the beginning of a program, you should first capture a locate point using one of the two MEMO locations. Press MEMORY START - its LED will light solid Press either ID SEARCH ( for beginning of desired program ) or the LOC key ( either 1 or 2 ) that corresponds to the desired memory point Tape will position itself and store audio into the memory buffer during which time the MEMORY START LED blinks Once the buffer is loaded, the tape repositions to the original cue point and the MEMORY START LED once again lights solid - the STOP button lights solid while the PLAY button blinks - the DA-60MKII is now in Memory Start Standby mode Note: The Memory Start function's performance may vary, depending upon the status of the Auto Cue feature. Screen 12 "iSdFt" and its three possible parameters (oFF, iS on, iS-cuE on) determines whether only MEMORY START or a combination of MEMORY START and AUTO CUE is automatically activated each time the unit is turned on. "Off" is the default parameter. Consult the Owner's Manual for more information. MEMORY START POINT TRIM 1) While in Memory Start Standby mode, press DATA - you will hear an audio loop approximately 200 msec. [. . . ] [. . . ]