User manual TASCO TRAIL CAMERA 119213C

[. . . ] The oversized xenon flash will reach out up to 30 feet for nighttime images. A new photo is taken every 30 seconds for as long as motion/heat events are detected. Install 4 "D" cell batteries (flat base of all batteries contacting springs), and insert an SD card (not included, use any capacity up to 8GB) in the slot to the right of the 5 buttons (upside down, brand name facing you). Press the card down until you hear it click into place. [. . . ] Open the Cam by pulling out on the two latches on the right side. Install 4 "D" cell batteries (flat base of all batteries contacting springs), and insert an SD card (not included, use any capacity from 16MB to 8GB. ) in the slot to the right of the 5 buttons as indicated on the slot cover (upside down, with the notched corner of the card on the left and metal contacts of the card facing the back of the slot). Press the card down until you hear it click into place. If the Cam is turned on without a card in place, it may not turn off-reset it by pulling one of the batteries out partway, insert a new or empty SD card, and put the battery back in place. Only remove or insert cards with power off. If you are using the camera for the first time, you should set the date and time so your photos will be "stamped" correctly. Briefly press the Menu buttonthe first two digits of the year will flash, prompting you to enter the year (a). Use the Up/Down buttons to set the current year, then press ENTER. Set the month the same way, and press ENTER again. The display will then change to let you set the day, with only the last two digits blinking (b). Again use the Up/Down buttons to change the day if necessary and press ENTER. To set the time, use Up/Down to set the hour and minute. By pressing UP/DOWN, the camera will cycle between Lo resolution still photo, Hi resolution still photo, and movie (video) modes. Choose the mode that you want and press ENTER. The "Lo" setting will allow you to take lower resolution images and therefore Accumulate more images on your card while the "HI" setting will give you high resolution images of better quality but fewer images can be stored to the card. In Movie mode a 14 second AVI file will be recorded to the SD Card each time the camera is triggered. Formatting is recommended before you re-use an old SD card, and is a quick way to erase all of the photos/videos after you've saved any d you wish to keep. The display will read "FoNo", with "No" and the SD card icon blinking (d). Press ENTER when "No" is flashing if you don't want to format the card. To format the card, press either UP/DOWN button and the "Fo" portion will blink. Press ENTER and the display will change to "Y N" with the SD card icon blinking. [. . . ] Congratulations on the purchase of your new Tasco product. This product is warranted against original defects in material and/or workmanship for the length of time specified by this warranty, provided, however, that the unit has not been abused, taken apart or tampered with in any way whatsoever. This warranty is limited to the original purchaser and is not transferable. This warranty applies only to products purchased in the United States of America. [. . . ]