User manual TEAC CD-W552G

[. . . ] When the drive is vertical mounted an 80mm disc cannot be played. Caution: Use of controls or adjustments or performance of procedures other than those specified herein may result in hazardous radiation exposure. If the protective housing of the device listed above is opened without the consideration of the appropriate processing, serious injuries may result caused by the effect of the laser beam. Note: Please use for the installation the fixing holes in the sides or on the bottom of the drive. Jumpers for IDE Configuration The strap (jumper) is factory-preset as shown below: Components Drive, Quick Installation Guide; Kit version only: 4 mounting screws M3x5mm, 40-pin IDE data cable, audio cable. The kit version can be identified if the product name ends with the letter "K" or "Kit". System requirements Your Drive supports all major operating systems (with the exception of Windows 3. 1x) and all major hardware platforms. [. . . ] (7) Connect the PC to the wall outlet and switch it on Important: If your PC will not start up correctly switch it off immediately and check all of the connections and jumper settings. Controls and Functions at the Front Panel (1) Open the case of your PC and lift it off carefully. (2) Configure the optical drive if necessary. (3) Locate a free slot for 13. 3cm / 5. 25" drives and install the Drive using the provided four screws. Emergency Eject Busy-LED Eject Key Important: Do not use screws which are longer than 5 mm! (4) Connect the power cable and the 40-pin data cable (assure the correct orientation, pin 1 is often marked with a color stripe) to the drive. Connecting in the wrong orientation may damage the drive and the_PC!(5) Connect the provided audio cable to the sound card. Usually sound cards offer more than one connector to connect an audio cable to. Please refer to the manual of the sound card to find the connector in question. Headphone Jack Volume-Control ON/BUSY indicator The indicator LED light in Seek, Play, Read, and Write operation. In the following table you will find a list including a description of the different drive states and their associated indicator states. Operation Write Audio Play Seek/Data Transfer At start LED Red LED lights Green LED flashes Green LED lights Green LED flashes Cleaning and maintenance of your CD-W552G Drive will not need maintenance if used as specified in this manual. Usually there are only problems with dirty or defective CD. Installing Drivers with Windows NT 4. 0 and OS/2 After installing the hardware, the reading functionality of the optical drive is activated with installing the drivers shipped with the corresponding operating system. The drivers may be configured and activated aided by the system control. Please refer to the manual of your operating system for any details. Compatibility Devices or Interoperability to other IDE Important: Do not use cleaning CDs which will remove dirt of the lense of the laser aided by a little brush. Do not clean the inner parts of your Drive with compressed air. Any of these methods may cause damage to your Drive. Handling: Check the CD before inserting it into the drive. It should not have finger prints or other dirt on it. Especially at high reading velocities dirt may increase the number of reading errors. [. . . ] (Default: PIO Mode-4) Burst DMA: 16. 6MB/s max. (Dafault: MW DMA Mode-2) Burst UDMA: 33. 3MB/s max. (Default: ULTRA DMA Mode-2) 100 ms typisch (pseudo-zufälliger Zugriff) entsprechend TEAC Standard 15 sec max. [. . . ]