User manual TEAC QUICK DV-W58E

[. . . ] If the protective housing of the device listed above is opened without the consideration of the appropriate processing, serious injuries may result caused by the effect of the laser beam. Note: Please use for the installation the fixing holes in the sides or on the bottom of the drive. Jumpers for IDE Configuration The strap (jumper) is factory-preset as shown below: Components Drive, Quick Installation Guide; Kit version only: 4 mounting screws M3x5mm, 40-pin IDE data cable, audio cable. The kit version can be identified if the product name ends with the letter "K" or "Kit". Digital Audio Output 40-pin IDE Cable Connector Analog Audio Output Power Connector System requirements Your Drive supports all major operating systems (with the exception of Windows 3. 1x) and all major hardware platforms. [. . . ] Do the same if the optical drive is reconfigured. Important: If your PC will not start up correctly switch it off immediately and check all of the connections and jumper settings. Controls and Functions at the Front Panel Busy-LED (1) Open the case of your PC and lift it off carefully. (2) Configure the optical drive if necessary. (3) Locate a free slot for 13. 3cm / 5. 25" drives and install the Drive using the provided four screws. Emergency Eject Eject Key Important: Do not use screws which are longer than 5 mm! Headphone Jack Volume-Control (4) Connect the power cable and the 40-pin data cable (assure the correct orientation, pin 1 is often marked with a color stripe) to the drive. Connecting in the wrong orientation may damage the drive and the_PC!(5) Connect the provided audio cable to the sound card. ON/BUSY indicator The indicator LED light in Seek, Play, Read, and Write operation. In the following table you will find a list including a description of the different drive states and their associated indicator states. Cleaning and maintenance of your TEAC Drive Usually sound cards offer more than one connector to connect an audio cable to. Please refer to the manual of the sound card to find the connector in question. Drive will not need maintenance if used as specified in this manual. Usually there are only problems with dirty or defective CD. Important: Do not use cleaning CDs which will remove dirt of the lense of the laser aided by a little brush. Do not clean the inner parts of your Drive with compressed air. Any of these methods may cause damage to your Drive. Handling: Check the CD before inserting it into the drive. It should not have finger prints or other dirt on it. Especially at high reading velocities dirt may increase the number of reading errors. Audio-Cable 40-pin Datakabel Power Cable Very important: Shape CD/DVD, a kind of CD/DVD which is not shaped like the normal round CD/DVD, are not allowed to be used in this drive. Otherwise rotational forces may cause severe damage to the drive. (6) Close the case of the PC. Do not forget to connect other devices and accessories if there are any. [. . . ] supported DVD-R/CD-R media speed or data transfer rate of the PC) 4 Drive Performance Data transfer rate (Asynchronous transfer) Access time Starting time from power on Programmed I/O: Burst DMA: Burst UDMA: 16. 7MB/s max. (Mode 0 to 2) 100 ms - average (CD-ROM 40x), 130 ms ­ average (DVD-ROM, 12 x) CD-ROM: 12 sec max. (exkluding multi-session) / DVD-ROM: 18 sec max. [. . . ]