User manual TECHNICS SA-AX730

[. . . ] Never leave the packing components (plastic bags, polystyrene foam, nails, etc. ) within the reach of children since these are a source of potential danger. The appliance must be installed by a qualified technician in compliance with the instructions provided by the manufacturer. The latter denies all responsibility for improper installation which may harm persons and animals and damage property. [. . . ] if in doubt , contact a qualified professional. Disconnect the appliance from the electricity supply before all operations. Connect your hob to the electrical system by means of a junction box: if the appliance is connected permanently to the mains, an omnipolar circuit breaker, accessible if necessary, with a minimum contact opening of 3 mm should be installed. Valid only for models with a power supply cable Some models are supplied with a single-phase power supply cable, and should consequently only be connected to the singlephase mains. Observe the wire colours, as indicated in the diagram attached. Collegamenti elettrici Tensione Frequenza Fusibili Sezioni To install the cable, proceed as follows: • unscrew the wire clamp screw and the contact screws. € to make the desired electrical connection (see table), use the jumpers housed inside the box. Position the power supply cable wires according to the indications in the table. € once the connections have been made, tighten all the terminal screws fully. € Fasten the supply cable in place with the clamp and close the cover of the terminal board. N L FR-BE-AT-DE-GR-ES-ILIT-NZ-PT-GP-CH-MA-LUIE-FI-SE-IS-GB-NL-DK 230V - 1+N~ 50Hz CY-MT-AU-NZ-KW 240V - 1+N~ 50Hz 25A * 2, 5 mm² BL BR This appliance conforms with the following European Community Directives: - 73/23/EEC of 19/02/73 (Low Voltage) and subsequent amendments; - 89/336/EEC of 03/05/89 (Electromagnetic compatibility) and subsequent amendments; - 93/68/EEC of 22/07/93 and subsequent amendments; - 2002/96/EC The European Directive 2002/96/EC on Waste Electrical and Electronic Equipment (WEEE), requires that old household electrical appliances must not be disposed of in the normal unsorted municipal waste stream. Turning off the hob Press the key; the appliance has been turned off. If you have locked the hob controls (see paragraph below), the same will still be locked when you turn the hob back on. Unlock the controls in order to operate the cooking zones. The booster The booster is only fitted on hobs KBT8424 IDO 400 KBT8424 IDO - KOT7424 IO 400 - KOT7424 IO - KBT 7124 ID - KBT6114 ID - KBT6323 IO - KBT 6013 ID - KBT 6124 ID 400 - KBT 6124 ID - KBT 6104 I CL. KBT8424 IDO 400 - KBT8424 IDO - KOT7424 IO KBT6323 IO: you may programme all the cooking zones simultaneously for a maximum cooking time of 99 minutes. Proceed as follows: • select the cooking zone by pressing the corresponding control key, • set the desired heating power using the “+” and “-” keys, • press the programming key , • set the desired cooking time using the “+” and “-” keys, • confirm your programming by pressing the programming again. The end of programmed cooking is signalled by a beep (one minute long) and the cooking zone concerned is turned off. P er level ow 1-2 3 4 5-6 7-8 9 M umdurationof operation axim 10hours 5 hours 4 hours 3 hours 2 hours 1 hour Overheating protection device Should your appliance’s electronic components overheat, the hob will turn off automatically and “—” will come up on the power level display. The letter will disappear as soon as the temperature drops back down to an acceptable level. For the attention of wearers of pacemakers or other active implants: The hob complies with all current standards on electromagnetic interference. Your induction hob is therefore perfectly in keeping with legal requirements (89/336/CEE directives). [. . . ] Never leave a cooking zone on without a pan on it as the maximum heat level would be reached very quickly, which could damage the heating elements. the glass ceramic hob is resistant to thermal and mechanical shocks. However, it may break due to a shock caused by a sharp object. In this case, unplug the appliance immediately and contact an authorised after-sales service centre to have it repaired. [. . . ]