User manual TECHNICS SC-EH600

[. . . ] Kindly save these instructions for future reference. Environment Protection Agency's Emissions limits for wood heaters manufactured and sold after July 1, 1990. Under specific test conditions, this heater has shown heat output at rates ranging from 13, 500 to 45, 900 BTU's per hour. The Jøtul SC-EH600 woodstove is only listed to burn wood. [. . . ] The container should be placed on a noncombustible floor or on the ground, well away from all combustible materials, pending final disposal. If the ashes are disposed of by burial in soil or otherwise locally dispersed, they should be retained in the closed container until all cinders have thoroughly cooled. Remove all remaining debris from the glass area using a wire brush. Apply a small bead of gasket/stove cement and the new gasket. Do not overlap the ends of the gasket rope. Center the new glass panel over the gasket and reinstall the glass clips. Important: The side of the glass treated with an infrared coating (marked on the perimeter) should always be facing outward. it is extremely important to tighten the glass clips slowly and in a repeating pattern , like tightening the lugs on an automobile wheel. It may be necessary to retighten the glass clips after the stove has burned and the gasketing has been seated. Replacement glass panels can be ordered through your Jøtul dealer. On occasion it will be necessary to clean the carbon deposits and fly ash off of the glass. Some care should be taken when operating the stove as a fireplace. Never over load the stove: For the best appearance burn in the traditional three log configuration. Reminder, when burning the stove with the screen in place, you are sacrificing efficiency for aesthetics, and you will be consuming wood at a much faster rate. Warning: Operate your Jøtul SC-EH600 with the front doors fully open and the firescreen in place or fully closed. Partially opened doors may result in overfiring. Also, if doors are left partly open, gas and flame may be drawn out of the stove opening, creating risks from both fire and smoke. To check the seal of the front doors, close and latch the doors on a dollar bill and slowly try to pull the dollar bill free. If it can be easily removed then the seal is too loose. Check several spots around the door, and repeat the procedure on the ash pan door as well. If gaskets need to be replaced, scrape out the old gasket and cement and clean the area with a wire brush. Apply a small bead of cement and push in the new gasket. [. . . ] Also check that all joints are sealed and that the gaskets are in the correct position. Any gaskets showing signs of wear or deformation must be replaced. Thoroughly clean the gasket grooves, apply ceramic glue (available from your local Jøtul dealer), and press the gasket well into place. The burn plate on the right door is fastened with a screw. [. . . ]