User manual TECHWOOD MD59

[. . . ] · Follow all warnings and instructions marked on the audio equipment. 1) Read instructions - All the safety and operating instructions should be read before the product is operated. 2) Retain instructions - The safety and operating instructions should be retained for future reference. 3) Heed Warnings - All warnings on the product and in the operating instructions should be adhered to. [. . . ] Input source, frequency and level indicator Function display : When you press input selection button, the selected input source will be shown. Frequency display : When you select Tuner input source, FM/AM frequency will be displayed. Surround Sound Level display : When you adjust the level of center, rear and delay when operating unit in surround mode, the level will be displayed in dB. 4. TAPE Monitor indicator This indicator will illuminate When you press TAPE MONITOR button. 5. STEREO indicator This indicator will illuminate when FM stereo broadcasting is received. The indicator will not light up on FM mono or AM broadcasting. 6. TUNED indicator This indicator will illuminate when a radio station is precisely tuned. 2. Memory Channel indicator The number of the memory channel which is selected will be displayed. 7. TIMER indicator This indicator will illuminate when the timer is used. 3. MEMORY indicator Press the MEMORY button and the MEMO indicatorwill light. If you press the MEMORY button and release instantly, the indicator will blink 4 times. If the unit or display malfunctions, try resetting the microprocessor as shown. RESET SWITCH -Rear PANEL- Sleep Timer Operation SLEEP Timer Function This function allows you to preprogram the receiver to switch the power off automatically. You can enjoy the audio/video system for a specified amount of time without having to worry about turning the unit off later. Each press of the SLEEP button changes the time indication by 10 minutes. SLEEP 90 SLEEP 80 ··· SLEEP 10 Press the RESET switch lightly once or twice with a pencil or a ballpoint pen. Note : When the RESET switch is pressed, all the memory will be cancelled. IMPORTANT NOTE : The following applies through out the "AUDIO and VIDEO OPERATIONS" sections unless otherwise noted. To simplify explanations, instructions refer to names of buttons and controls on the front panel, making no mention of the use of remote control unit. To listen to a source other than tape deck, press the TAPE MONITOR button to the OFF position (the TAPE monitor indicator will not light in the display). (No timer setting) To determine how much time remains after the sleep timer has been set, press the sleep button again, the remaining time will be displayed. To turn the sleep timer off after it has been set, press the sleep button repeatedly until the timer counts down and the tuner display lights up with radio frequency. 13 Basic Operations Audio Adjustments 1. Set the MASTER VOLUME control to "0". This is to protect the speakers from a sudden high-level signal. Set the LOUDNESS button to the OFF position. [. . . ] Speaker impedance is less than prescribed for this unit. Place this product as far away as possible from electric devices with interference. After turning off the power and then turning it on again, reduce the volume or change to the correct 8 ohm speakers. Press the MAIN or SURROUND speaker selector as applicable. [. . . ]