User manual TECHWOOD PL73

[. . . ] · Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. · Consult your local store or an experienced radio/TV technician for help. · If you cannot eliminate the interference, the FCC requires that you stop using your system. Changes or modifications not expressly approved may cause interference and void the user's authority to operate the equipment. ! C AU T I O N : TO R E DUC E T HE R IS K OF E LE C T R IC S HOC K , DO NOT R E MOV E C OV E R OR B AC K . [. . . ] To restore the sound, press again. SLEEP -- Press to set the sleep time. Important: If you change functions using the function knob on the front of the receiver, you must also press the corresponding function button on the remote control to operate the unit with the remote control. OPERATING RANGE OF THE REMOTE CONTROL The remote control may not work properly if: · There are obstacles between the remote control and the receiver's remote sensor. · Direct sunlight or fluorescent light is shining onto the remote sensor. · The receiver is located near a device that is emitting infrared rays. · The receiver is operated simultaneously with another infrared remote control. 13 SETTING UP THE SURROUND SOUND SYSTEM If you purchased the PL73 with mini or bookshelf speakers and a powered subwoofer, you do not have to set the speaker sizes. The PL73 comes from the factory pre-set for use with small front, center and rear speakers and a powered subwoofer. If you purchased the PL73 with large floor standing speakers or change your speakers at a later date, you must set speaker sizes using the SPEAKER CONFIG function on the remote control as described below. You can also adjust the channel output levels and speaker distances as described below. 3. Press SPEAKER LEVEL again and C 0dB (center) appears. To change the center speaker's level, repeatedly press or until you reach the desired level ( -10 to +10dB ). Press SPEAKER LEVEL again and FR 0dB (front right) appears. To change the front right speaker's level, repeatedly press or until you reach the desired level ( -10 to +10dB ). again and SR 0dB (surround right) appears. To change the distance between the listening position and the center speaker, repeatedly press or until you reach the desired level ( 0 to 30 FT ). Press SPEAKER DELAY again and S 20dB (surround)appears. To change the distance between the listening position and the surround speakers, repeatedly press or until you reach the desired level ( 0 to 30 FT ). Press SPEAKER DELAY again to exit. Changing the Channel Level The default channel level settings for each speaker is set to 0 dB . You can adjust the sound level for each speaker to suit the listening area in your home. For example, if you are closer to the left front speaker than to the right front speaker, the left front speaker might seem "louder" than the right one. To adjust it, you must change the channel level for one or both speakers until the proper balance is achieved Follow these steps to change the channel level using the remote. Press SPEAKER LEVEL , and CH LEVEL appears. Press SPEAKER LEVEL again and FL 0dB(front left)appears. To change the front left speaker's level, repeatedly press or until you reach the desired level ( -10 to +10dB ). 14 Surround Effects I mportant: The center and rear speakers only operate when the unit is set to a surround sound mode and the source material being played is recorded or broadcast in Dolby Digital, DTS or Dolby Pro Logic surround sound. [. . . ] Check all speakers for correct polarity. Set the mode to the desired surround mode position. Check all rear speaker wires for good connection. Set Surround Mode toDTS, DOLBY DIGITAL, DOLBY PRO LOGIC, DOLBY PRO LOGIC II No sound from the rear Surround Mode is set toSTEREO. [. . . ]