User manual TECOM AR4031C DATASHEET

[. . . ] Operation is subject to the following two conditions: 1. This device may not cause harmful interface 2. This device must accept any interface received, including interface that may cause undesired operation. These limits are designed to provide reasonable protection against harmful interface in a residential installation. [. . . ] Make sure the value is 1400 or smaller than 1400. Router Username: Set the username for access to these configuration pages. Leave this field and Router Password blank to disable access control. Router Password: Set the password for access to these configuration pages. Leave this field and Router Username blank to disable access control. Router WAN Port: Set the WAN port to use the remote access to these configuration pages. Leave this field blank to disable remote access. Router Mode: Router Mode is default. If you select Access Point Mode that is disabling LAN DHCP Server, LAN Spanning Tree Protocol, and WAN Protocol. Firewall: Connections from the WAN are allowed if the Firewall is disabled. Note If your ISP has provided the DHCP functionality, you should select the Router Mode. The capability of Access Point Mode is similar to the single Hub, and doesn't support the DHCP function. The other relevant setting: Figure 9. Time Zone: Set the Time Zone of this locale. NTP Server: Set the IP address of the NTP Server to use for time synchronization. To cancel your changes, click the Cancel button. ! 21 Wireless Use the Wireless screen to configure your router for wireless access. The Wireless screen is shown in the figure below. Figure 15. Wireless Interface: Select which wireless interface to configure. Network Name (SSID): This field is the network name shared among all devices in a wireless network. The SSID must be identical for all devices in the wireless network. It is case-sensitive and must not exceed 32 alphanumeric characters, which may be any keyboard character. Make sure this setting is the same for all devices in your wireless network. Network Type: When wireless clients survey the local area for wireless networks to associate with, they will detect the SSID broadcast by the router. To broadcast the router's SSID, keep the default value Open. If you do not want to broadcast the router's SSID, then select Closed. [. . . ] WEP protects data as it's transmitted from one end point to another. WEP is used at the two lowest layers, the data link and physical layer. WEP is designed to make up for the inherent security in wireless transmission as compared to wired transmission. 9. Shared Key Authentication: Set whether shared key authentication is required to associate. [. . . ]