User manual TEFAL AMBIANCE COMPACT

[. . . ] - grasp the handle of the protective hood to carry your steam generator (2). Place your steam generator on a stable, horizontal heat-resistant surface. Grasp the handles of the removable tank and pull horizontally to remove it (3). Fill up the water tank taking care not to exceed the maximum level just below the filler cover (4). [. . . ] Place it on the iron-rest on the base unit : it has non-slip pads and has been designed to withstand high temperatures. Empty and rinse the removable water tank (17). Regularly clean the soleplate with a damp, non-metallic washing up pad. Clean the plastic parts of the appliance occasionally with a soft cloth. ·· Synthetic, Polyester, Acetate, Acrylic, Polyamide linen lin cotton coton wool laine soie silk synthetic synth. · To obtain steam, press on the steam control button beneath the iron handle and keep it pressed (11). The steam will stop when you release the button. It is recommended that you start with fabrics to be ironed at a low temperature: synthetics (). For delicate fabrics (), press the steam control button (under the handle of the iron) intermittently to avoid possible water droplets appearing with the steam. There is no more steam. The removable water tank is empty (12). Raise the 2 parts of the hood over the iron until the protection system locks into place (audible click) (13). Grasp the handles of the removable tank and pull horizontally to remove it ; fill with water. Replace and push it firmly into place 4. Press the release button for the hood and fold it down over the tank (14). (11) 11. THE ORANGE "BOILER RINSE" LIGHT FLASHES Note: · To extend the efficient operating life of your boiler and avoid scale particles on your linen, your generator is equipped with an orange "boiler rinse" warning light that flashes on the control panel after about 10 uses. · If your water is hard, increase the frequency. Before attempting to rinse the boiler of your generator, it is essential to leave it to cool for at least 2 hours in order to avoid any risk of scalding. If the orange "boiler rinse" light flashes, you can continue ironing normally but remember to rinse the boiler first, the next time that you use it. Check that the generator is cold and unplugged. The protective hood must be folded down over the tank. Place your steam generator on the edge of your sink, with the iron to one side, standing on its heel. Unscrew the cord clip by turning a quarter turn to the left (18). Using a coin, gently unscrew the boiler rinse plug (19). Place the plastic nozzle 1 of the rinsing pipe into the hole of the boiler and turn gently to the right until it locks. The outlet of this nozzle must be positioned over the sink (20). Connect the rubber end 2 of the rinsing pipe to a cold tap (21). Turn the tap on gently and gradually and let cold water run through the rinsing pipe into the sink for about 1 minute (22). [. . . ] · Press the steam control button away from your ironing board until the iron produces steam. · Stop using the turbo steam function and allow the thermostat light to come on and go off again before using this function again. · Rinse out the boiler after every 10 uses, when the orange indicator light flashes (see chapter 11). If your water is hard, increase the frequency. [. . . ]