User manual TEFAL COMPACT TOASTER 5396

[. . . ] Remove the sole plate protector before heating up the iron (depending on the model). 2- DRY IRONING - Set the steam control on DRY (see diagram A). - You may start ironing when the thermostat light goes out and comes on again. Warning !Before using your iron with the steam function for the first time, we recommend that you operate it in horizontal position for a few moments, away from your linen, ie press several times on the shot of steam button. During the first few uses, a harmless odour and smoke may be given off. This has no effect on the use of the iron and will disappear quickly. What temperature and which steam setting to use ? FABRIC LINEN COTTON WOOL SILK Polyester, Acetate, Acrylic, Nylon POSITION OF THERMOSTAT CURSOR MAX STEAM SETTING POSITION MAX SYNTHETIC qqq qq q q 3- MAINTAINING YOUR IRON BE CAREFUL ! [. . . ] - Plug in your iron and wait until the thermostat light goes out. - Unplug the iron and hold it over a sink in the horizontal position. - Raise the anti-calc valve without removing it completely. - Shake the iron gently, over the sink, until all of the water in the water tank (with the impurities) has flowed out via the sole plate. - At the end of the operation, push the anti-calc valve back into position. - Turn the iron back on for 2 minutes, setting it on its heel, to dry the sole plate. - Unplug the iron, and when the soleplate is just warm, wipe it with a soft cloth. Recommendation : The self-cleaning function helps to delay the scaling of your iron. 4- STORING YOUR IRON - Unplug it and wait until the sole plate has cooled off. - Empty the water tank and set the steam control to DRY. - Store the iron on its heel. FOR YOUR SAFETY · Warning!The voltage of your electrical installation must correspond to that of the iron (220V-240V or 127 V depending on the model). Connecting to the wrong voltage may cause irreversible damage to the iron and will invalidate the guarantee. · Set the thermostat in the coloured zone (from qq to MAX). · Wait until the thermostat light goes out. · Wait a few seconds between each use of the button. · See the section "Storing your iron". · Do not add any descaling agents to the water in the water tank. · Do a self-cleaning and use tap water or 50 % tap water and 50 % demineralized water. . · Clean the sole plate with a non-metallic sponge. Vacuum the holes of the sole plate from time to time. · Ensure linen is rinsed thoroughly to remove any soap deposits or chemicals on new garments which have been sucked up by the iron. · Clean the sole plate as indicated above. See the temperature table to correctly set the thermostat. [. . . ] · The wire that is coloured BLUE must be connected to the terminal which is marked with the letter N or coloured BLACK. · This appliance requires a 13 amp fuse. · Should the fuse need to be replaced an ASTA marked fuse, approved to BS 1362, of the same rating must be used. · Always replace the fuse cover after fitting a fuse. The plug must NOT be used if the cover is omitted or lost until a replacement is obtained ­ make certain that only the correct fuse cover is used and fitted. [. . . ]