User manual TEFAL OV5750

[. . . ] 13 For selecting the ideal cooking method for your recipe. 12 This lets you set the temperature from 80°C to 250°C or 260°C*. Conversion table Position of Temperature thermostat in °C 1 80 2 100 3 120 4 140 5 160 6 180 7 200 8 220 9 240 10 250/260 You can change your settings during cooking. 11 Once you have activated the timer and the thermostat is switched on, the pilot light or interior lighting* comes on and the oven is functioning. [. . . ] 6 Grill or pulsed air grill function* Grill function For browning the tops of dishes or searing meat. Place food on the rack at the closest possible level to the grill's heating element. Put a dish with a little water directly onto the smooth floor (which does not heat in grill position), to collect fat or cooking juices. Set the timer as indicated in your recipe Fig. 11 , or turn the on/off switch to "I"* - Fig. Half-way through cooking, turn over the *depending on model Oven function For cooking or reheating meat, fish, gratins, soufflés, pastries, etc. Place the rack at the required height - Fig. 7 and 8 . 12 2780-MAQ1 ME FOUR 20 L FATGA 10/10/02 10:21 Page 13 food that is being grilled. Pulsed air grill function* For ending up with juicier meat and fish = the grill and fan function simultaneously. Put the function selector on to the pulsed air grill position - Fig. 17 Continue as for the grill function. Roasting spit function* For installing the roasting spit, insert the spit holder into the holes on the left-hand sidewall of the oven - Fig. 19 Slide a fork onto the spit (points inwards) and screw it in tightly. Tie meat and poultry before placing on the spit, then slide the second fork in as far as possible, points still inwards, so that the roasting joint is held firmly in place - Fig. 20 Unscrew the first fork if necessary in order to re-centre the joint on the spit and block both forks. Pull out the rack and insert a tray at the bottom of the oven - Fig. 21 (on the floor which does not heat in the roasting spit position). Insert the pointed end of the spit into the drive opening located on the right-hand sidewall of the oven and push it in as far as it will go - Fig. 22 Position the other end of the spit on the spit holder - Fig. 23 Put the function selector on to the roasting spit position - Fig. Pull the spit to release it from the axis. [. . . ] · If the cord is detachable, connect it first to the appliance and then to the electricity supply. · Do not let the cord hang down or touch hot parts of the oven. Do not disconnect the appliance by pulling on the cord. · Only use an extension lead that is in good condition, with an earthed plug and power cable at least equivalent to the cord supplied with the product. [. . . ]